Lucent Technologies 20 manual Using the commands, Viewing the main menu

Page 18

Command-Line Interface

Using the commands

Using the commands

The CLI of the CellPipe 20 Series consists of two hierarchical levels. Some of the second-level commands display values or status of the selected commands from the main level.

Note: Access to the CLI is possible without a password. When user enables a password, the unit will time-out after 10 minutes if there is no activity on the unit. Re-entering password is necessary to resume activity.

The CellPipe 20 Series units display two sets of main menu commands based on the mode of operation—bridging or routing. The default list of main menu commands is for bridging. See “Bridging commands” on page 3-3. When selected for routing, the routing menus are displayed. See “Routing commands” on page 3-6.

Viewing the main menu

To view a list of the main menu commands, enter help at the >> prompt.

>>help

Displaying information about a command

To display information about a command, enter help followed by the name of the command.

For example, in the LAN menu, you can display information about the setip command as follows:

>lan> help setip

setip

- setip <etherip[/<masknum>]> [subnet mask]

where etherip is the required information and [masknum] and [subnet mask] are optional information.

3-2

CellPipe™ 20 Series User’s Guide

Image 18
Contents CellPipe 20 Series Lucent Technologies Finding information and software Customer ServiceCustomer Service Obtaining technical assistanceCustomer Service Contents Upgrading System Software Introduction About this guideWhat is the CellPipe 20 Series Product Family? What is the CellPipe 20 Series Product Family?Lucent TURN-UP CellPipe 20 Series managementLucent TURN-UP Page Setup Verifying package contentsItems you need for installation Connecting CellPipe 20 Series productsItems you need for installation Connecting CellPipe 20 Series products CellPipe 20 Series rear panelsConsole setup Checking status lightsChecking status lights Console setup Page Command-Line Interface Syntax of command-line interfaceUsing the commands Using the commandsDisplaying information about a command Viewing the main menuSaving configurations Bridging commandsDisplaying second-level commands Bridging commandsMain menu Second-level menus/description Set all configuration to factory setting Routing commands Routing commandsAdditional main-menu and second-level routing commands Command-Line Interface Command-Line Interface Page Configuring a 20 Series CellPipe Auto-provisioningConfiguring WAN interface Sdsl commands and configurationsConfiguring WAN interface Select the dbit command to configure the sdsl data bit Adsl commands and configurations Select the abort command to abort the Adsl connection Multimode Configuring LAN interface Configuring LAN interface in bridging modeConfiguring LAN interface Configuring LAN interface in routing mode Configuring the manage command Configuring the mode commandConfiguring the manage command Quick command in routing mode Configuring the quick commandQuick command in bridging mode Configuring the quick commandConfiguring the r1483 command R1483 command in bridging modeConfiguring the r1483 command R1483 command in routing mode Configuring the dnsrelay command Configuring the ipoa commandConfiguring the dnsrelay command Configuring the pppoa command Configuring the pppoa commandConfiguring the pat command Configuring the pat commandSelect the show command to display the Pat configuration Preparing to upgrade Upgrading System SoftwareObtaining software Upgrading software Upgrading softwareProduct warranty Warranties and FCC RegulationsFCC Part 15 Notice Warranty repairOut-of warranty repair FCC Part 15 NoticeIC CS-03 Notice IC CS-03 Notice