Lucent Technologies 20 manual Select the show command to display the Pat configuration

Page 42

Configuring a 20 Series CellPipe

Configuring the pat command

Select the addpatin command to enable a local server’s IP address to be used as a WAN access port.

>pat> addpatin <pppoawanip> <port>/<udptcp> <serverip>

Note: Prior to setting the local server as a WAN access port, you have to enable the PAT function. See the setpat command below.

Select the delpatin command to disable the local server as a WAN access port.

>pat> delpatin <all><number>

Select the setpat command to enable or disable a specific PAT interface.

>pat> setpat <pppoawanip> <e>nable<d>isable

Select the show command to display the Pat configuration.

>pat> show

PAT enabled interface:

Interface IP address

IPoA 210.62.2.195

PPPoA?.?.?.?

PAT incoming table
No.	i/f nameWAN IP	Port/Protocol	Server IP
1	pppoa	434/udp	192.62.2.134
2	210.62.2.195	232/tcp	192.62.2.166

4-16	CellPipe™ 20 Series User’s Guide

Image 42

Contents CellPipe 20 Series Lucent Technologies Finding information and software Customer ServiceCustomer Service Obtaining technical assistanceCustomer Service Contents Upgrading System Software Introduction About this guideWhat is the CellPipe 20 Series Product Family? What is the CellPipe 20 Series Product Family?Lucent TURN-UP CellPipe 20 Series managementLucent TURN-UP Page Setup Verifying package contentsItems you need for installation Connecting CellPipe 20 Series productsItems you need for installation Connecting CellPipe 20 Series products CellPipe 20 Series rear panelsConsole setup Checking status lightsChecking status lights Console setup Page Command-Line Interface Syntax of command-line interfaceUsing the commands Using the commandsDisplaying information about a command Viewing the main menuSaving configurations Bridging commandsDisplaying second-level commands Bridging commandsMain menu Second-level menus/description Set all configuration to factory setting Routing commands Routing commandsAdditional main-menu and second-level routing commands Command-Line Interface Command-Line Interface Page Configuring a 20 Series CellPipe Auto-provisioningConfiguring WAN interface Sdsl commands and configurationsConfiguring WAN interface Select the dbit command to configure the sdsl data bit Adsl commands and configurations Select the abort command to abort the Adsl connection Multimode Configuring LAN interface Configuring LAN interface in bridging modeConfiguring LAN interface Configuring LAN interface in routing mode Configuring the manage command Configuring the mode commandConfiguring the manage command Quick command in routing mode Configuring the quick commandQuick command in bridging mode Configuring the quick commandConfiguring the r1483 command R1483 command in bridging modeConfiguring the r1483 command R1483 command in routing mode Configuring the dnsrelay command Configuring the ipoa commandConfiguring the dnsrelay command Configuring the pppoa command Configuring the pppoa commandConfiguring the pat command Configuring the pat commandSelect the show command to display the Pat configuration Preparing to upgrade Upgrading System SoftwareObtaining software Upgrading software Upgrading softwareProduct warranty Warranties and FCC RegulationsFCC Part 15 Notice Warranty repairOut-of warranty repair FCC Part 15 NoticeIC CS-03 Notice IC CS-03 Notice