Lucent Technologies Connecting CellPipe 20 Series products, CellPipe 20 Series rear panels

Page 13

Setup

Connecting CellPipe 20 Series products

Figure 2-2. CellPipe 20 Series rear panels

CellPipe 20A-GX

CellPipe 20S

To connect up the CellPipe 20 Series units, proceed as follows:

1LAN connections:

•On the CellPipe 20A-GX, use the provided Ethernet cable (yellow) to connect the ETHERNET port to the NIC on a computer or to an appropriate networking component.

•On the CellPipe 20S, use the provided Ethernet cables to connect the four LAN ports (1X, 2X, 3X, 4X) to NICs on computers or to appropriate networking components.

2WAN connections:

•Use the blue WAN cable to connect the WAN port to a wall xDSL connector set up by your service provider.

3Connect the power cable and power up the unit.

Note: Apply power last. Doing so turns on the unit, which does not have a power switch.

CellPipe™ 20 Series User’s Guide

2-3

Image 13

Contents CellPipe 20 Series Lucent Technologies Customer Service Customer ServiceFinding information and software Obtaining technical assistanceCustomer Service Contents Upgrading System Software About this guide IntroductionWhat is the CellPipe 20 Series Product Family? What is the CellPipe 20 Series Product Family?CellPipe 20 Series management Lucent TURN-UPLucent TURN-UP Page Verifying package contents SetupConnecting CellPipe 20 Series products Items you need for installationItems you need for installation CellPipe 20 Series rear panels Connecting CellPipe 20 Series productsChecking status lights Console setupChecking status lights Console setup Page Syntax of command-line interface Command-Line InterfaceDisplaying information about a command Using the commandsUsing the commands Viewing the main menuDisplaying second-level commands Bridging commandsSaving configurations Bridging commandsMain menu Second-level menus/description Set all configuration to factory setting Routing commands Routing commandsAdditional main-menu and second-level routing commands Command-Line Interface Command-Line Interface Page Auto-provisioning Configuring a 20 Series CellPipeSdsl commands and configurations Configuring WAN interfaceConfiguring WAN interface Select the dbit command to configure the sdsl data bit Adsl commands and configurations Select the abort command to abort the Adsl connection Multimode Configuring LAN interface in bridging mode Configuring LAN interfaceConfiguring LAN interface Configuring LAN interface in routing mode Configuring the mode command Configuring the manage commandConfiguring the manage command Quick command in bridging mode Configuring the quick commandQuick command in routing mode Configuring the quick commandR1483 command in bridging mode Configuring the r1483 commandConfiguring the r1483 command R1483 command in routing mode Configuring the ipoa command Configuring the dnsrelay commandConfiguring the dnsrelay command Configuring the pppoa command Configuring the pppoa commandConfiguring the pat command Configuring the pat commandSelect the show command to display the Pat configuration Upgrading System Software Preparing to upgradeObtaining software Upgrading software Upgrading softwareWarranties and FCC Regulations Product warrantyOut-of warranty repair Warranty repairFCC Part 15 Notice FCC Part 15 NoticeIC CS-03 Notice IC CS-03 Notice