Lucent Technologies 20 manual Adsl commands and configurations

Page 30

Configuring a 20 Series CellPipe

Configuring WAN interface

>sdsl> smbit <NormalReverse>

Select the status command to display the configuration and status of the current SDSL setting. For example:

>sdsl> status

>version : Ver 2.31 Date 19/Feb/2001

terminal	- cpe
auto	- enable
rate	- 2320
maxrate	- 2320
smbit	- reverse
dbit	- normal
scramble	- enabled
cell	- disabled

Status :

Bitpump F/W Version : 5.1

Bitpump : present

CO/RT Select : cpe

Auto Rate : enable

Current Rate : 272

Max Rate : 2320

Sign/Magnitude Bit Sequence : reverse

Data Bit Polarity : normal

DSL Status : during startup

Line Quality : -16.0

Attenuation : 31.5

Select the terminal command to configure the modem to COE or CPE mode.

>sdsl> terminal <Coe><CPe>

ADSL commands and configurations

The following is a list of the menus available under the adsl command:

abort	- abort ADSL line
bitdn	- ADSL downstream bit loading value
bitup	- ADSL upstream bit loading value

4-4	CellPipe™ 20 Series User’s Guide

Image 30

Contents CellPipe 20 Series Lucent Technologies Finding information and software Customer ServiceCustomer Service Obtaining technical assistanceCustomer Service Contents Upgrading System Software Introduction About this guideWhat is the CellPipe 20 Series Product Family? What is the CellPipe 20 Series Product Family?Lucent TURN-UP CellPipe 20 Series managementLucent TURN-UP Page Setup Verifying package contentsItems you need for installation Connecting CellPipe 20 Series productsItems you need for installation Connecting CellPipe 20 Series products CellPipe 20 Series rear panelsConsole setup Checking status lightsChecking status lights Console setup Page Command-Line Interface Syntax of command-line interfaceUsing the commands Using the commandsDisplaying information about a command Viewing the main menuSaving configurations Bridging commandsDisplaying second-level commands Bridging commandsMain menu Second-level menus/description Set all configuration to factory setting Routing commands Routing commandsAdditional main-menu and second-level routing commands Command-Line Interface Command-Line Interface Page Configuring a 20 Series CellPipe Auto-provisioningConfiguring WAN interface Sdsl commands and configurationsConfiguring WAN interface Select the dbit command to configure the sdsl data bit Adsl commands and configurations Select the abort command to abort the Adsl connection Multimode Configuring LAN interface Configuring LAN interface in bridging modeConfiguring LAN interface Configuring LAN interface in routing mode Configuring the manage command Configuring the mode commandConfiguring the manage command Quick command in routing mode Configuring the quick commandQuick command in bridging mode Configuring the quick commandConfiguring the r1483 command R1483 command in bridging modeConfiguring the r1483 command R1483 command in routing mode Configuring the dnsrelay command Configuring the ipoa commandConfiguring the dnsrelay command Configuring the pppoa command Configuring the pppoa commandConfiguring the pat command Configuring the pat commandSelect the show command to display the Pat configuration Preparing to upgrade Upgrading System SoftwareObtaining software Upgrading software Upgrading softwareProduct warranty Warranties and FCC RegulationsFCC Part 15 Notice Warranty repairOut-of warranty repair FCC Part 15 NoticeIC CS-03 Notice IC CS-03 Notice