Lucent Technologies 20 manual Console setup

Page 15

Setup

Console setup

Set your communications software to connect with the following settings:

•Connection—Specify a direct connection from the unit to the computer.

•Serial port—Specify the serial port on the computer the software is to use.

•Terminal type—Specify VT100.

•Duplex—Specify Full. This is the default for most communications software.

•Bits per second—Specify 9600.

•Data bits—Specify 8.

•Parity—Specify None.

•Stop bits—Specify 1.

•Flow control—Specify None.

A >> prompt appears when the connection is completed.

CellPipe™ 20 Series User’s Guide

2-5

Image 15

Contents CellPipe 20 Series Lucent Technologies Obtaining technical assistance Customer ServiceCustomer Service Finding information and softwareCustomer Service Contents Upgrading System Software About this guide IntroductionWhat is the CellPipe 20 Series Product Family? What is the CellPipe 20 Series Product Family?Lucent TURN-UP CellPipe 20 Series managementLucent TURN-UP Page Verifying package contents SetupItems you need for installation Connecting CellPipe 20 Series productsItems you need for installation CellPipe 20 Series rear panels Connecting CellPipe 20 Series productsConsole setup Checking status lightsChecking status lights Console setup Page Syntax of command-line interface Command-Line InterfaceViewing the main menu Using the commandsDisplaying information about a command Using the commandsBridging commands Bridging commandsDisplaying second-level commands Saving configurationsMain menu Second-level menus/description Set all configuration to factory setting Routing commands Routing commandsAdditional main-menu and second-level routing commands Command-Line Interface Command-Line Interface Page Auto-provisioning Configuring a 20 Series CellPipeConfiguring WAN interface Sdsl commands and configurationsConfiguring WAN interface Select the dbit command to configure the sdsl data bit Adsl commands and configurations Select the abort command to abort the Adsl connection Multimode Configuring LAN interface Configuring LAN interface in bridging modeConfiguring LAN interface Configuring LAN interface in routing mode Configuring the manage command Configuring the mode commandConfiguring the manage command Configuring the quick command Configuring the quick commandQuick command in bridging mode Quick command in routing modeConfiguring the r1483 command R1483 command in bridging modeConfiguring the r1483 command R1483 command in routing mode Configuring the dnsrelay command Configuring the ipoa commandConfiguring the dnsrelay command Configuring the pppoa command Configuring the pppoa commandConfiguring the pat command Configuring the pat commandSelect the show command to display the Pat configuration Preparing to upgrade Upgrading System SoftwareObtaining software Upgrading software Upgrading softwareWarranties and FCC Regulations Product warrantyFCC Part 15 Notice Warranty repairOut-of warranty repair FCC Part 15 NoticeIC CS-03 Notice IC CS-03 Notice