Lucent Technologies 20 manual Upgrading software

Page 44

Upgrading System Software

Upgrading software

Upgrading software

Follow the procedure below to upgrade software:

1Extract the loads from eSight to your computer.

2Establish an Ethernet connection between the unit and your computer.

3Set up IP addresses on the unit and your computer such that you can successfully ping the unit.

4Under the DOS prompt on your computer, enter the path to the directory containing the extracted loads and a file named xupgrade.bat.

5To start the upgrade, execute command xupgrade <ipaddress of unit>, for example:

C:\> xupgrade 149.198.65.46

Note: There is no need to back up your current configuration. Using the xupgrade.bat file for upgrading will retain your current configuration. The upgrading process might last as long as 60 seconds.

6Then enter the restart command to reboot the unit.

7Lastly enter the save command to save the new upgrade.

Note: Maintain stable power to the unit while upgrading software. If power fails during the upgrading process, contents in the memory could be destroyed and the system will hang and no longer function.

5-2

CellPipe™ 20 Series User’s Guide

Image 44
Contents CellPipe 20 Series Lucent Technologies Customer Service Customer ServiceFinding information and software Obtaining technical assistanceCustomer Service Contents Upgrading System Software Introduction About this guideWhat is the CellPipe 20 Series Product Family? What is the CellPipe 20 Series Product Family?Lucent TURN-UP Lucent TURN-UPCellPipe 20 Series management Page Setup Verifying package contentsItems you need for installation Items you need for installationConnecting CellPipe 20 Series products Connecting CellPipe 20 Series products CellPipe 20 Series rear panelsChecking status lights Console setupChecking status lights Console setup Page Command-Line Interface Syntax of command-line interfaceUsing the commands Displaying information about a commandUsing the commands Viewing the main menuBridging commands Displaying second-level commandsSaving configurations Bridging commandsMain menu Second-level menus/description Set all configuration to factory setting Routing commands Routing commandsAdditional main-menu and second-level routing commands Command-Line Interface Command-Line Interface Page Configuring a 20 Series CellPipe Auto-provisioningConfiguring WAN interface Configuring WAN interfaceSdsl commands and configurations Select the dbit command to configure the sdsl data bit Adsl commands and configurations Select the abort command to abort the Adsl connection Multimode Configuring LAN interface Configuring LAN interfaceConfiguring LAN interface in bridging mode Configuring LAN interface in routing mode Configuring the manage command Configuring the manage commandConfiguring the mode command Configuring the quick command Quick command in bridging modeQuick command in routing mode Configuring the quick commandConfiguring the r1483 command Configuring the r1483 commandR1483 command in bridging mode R1483 command in routing mode Configuring the dnsrelay command Configuring the dnsrelay commandConfiguring the ipoa command Configuring the pppoa command Configuring the pppoa commandConfiguring the pat command Configuring the pat commandSelect the show command to display the Pat configuration Obtaining software Preparing to upgradeUpgrading System Software Upgrading software Upgrading softwareProduct warranty Warranties and FCC RegulationsWarranty repair Out-of warranty repairFCC Part 15 Notice FCC Part 15 NoticeIC CS-03 Notice IC CS-03 Notice