Polycom 8002 manual Startup Sequence, Icon Icons shown in bold turns off when, Ext, Xxxxx

SpectraLink 8002 Wireless Telephone Overview

Startup Sequence

			The SpectraLink 8002 Wireless Telephone goes through an
			initialization sequence at startup. The line icons 1-9 display and count
			down as the handset steps through this sequence. This is usually very
			rapid. If there is difficulty at any step that prevents initialization from
			continuing, an error message will display and the related icon(s) will
			stay on. Please see the error table at the back of this document for
			instructions on how to handle error messages that occur during
			initialization.
	Icon		The icon(s) shown in bold turns off when:
123456789			The handset has located and authenticated and associated with at least one AP, and is
			proceeding to bring up higher-layer networking functions.
12345678			The handset is either configured for Static IP, or if configured for DHCP, the DHCP
			discovery process has started.
1234567			If DHCP is configured, a DHCP response was received which contains a good DNS
			server configuration.
123456		Indicates Static IP configuration.
12345			All networking functions are complete (notably, DHCP) and the handset is establishing
			its connection to the LAN.
1234			The LAN connection is complete.
123			The handset has located a generic SIP config file.
12			The handset has located a handset-specific SIP config file.
	(no icons)		Handset is attempting to register each of the specified line contacts.
	Registering
	(no icons)		Handset has registered with at least one contact on one proxy server. Initialization is
	EXT.
			complete. The handset is in standby mode ready to receive and place calls. The line one
	XXXXX
			contact is displayed.
			During the last three steps of this process, the handset contacts the SIP
			TFTP server and downloads general information about the proxy
			server(s), downloads specific information pertaining to the handset,
			registers with the proxy server(s), and verifies handset credentials.
			Once this process is complete, the handset is ready to use.

PN: 1725-36034-001_C.doc 19