Polycom 8002 manual Proxy server commands, Parameter Value Description, Ser

Programming the SIP Handset Features

Proxy server commands

Use the following parameters when programming the configuration files. See the sample configuration files following this table for more detailed information.

Parameter		Value	Description	Notes
PROXYn_ADDR		xxx.xxx.xxx.xxx:	Proxy address. One	n = 1, 2, 3
		pppp	proxy address is	xxx.xxx.xxx.xxx = IP address
			required but
		or		pppp = port (optional, 5060 is
			additional proxy
				the default)
			addresses may be
			used to register
			secondary line
			appearances.
		proxyname:pppp		proxyname = proxy server
				name (DHCP only)
PROXYn_DOMAIN		Domain name	Domain served by	n = 1, 2, 3
			this proxy server.	DOMAIN = [example:
				spectralink.com]
				Can be omitted if a specific
				proxy domain name is not
				defined at the proxy server. If
				omitted, defaults to the IP
				address of the proxy server
				(see above)
PROXYn_TYPE	Asterisk		Specify the	Used by the handset to
		SER	manufacturer of each	perform proxy-specific actions
			defined proxy server.	based on known behavior for
				specific proxy types. Omit this
				parameter if the value is not
				Asterisk or SER.
PROXYn_KEYPRESS_2833	*enable		Controls generation	n = 1, 2, 3
		disable	of in-stream
			RFC2833 formatted
			key press events.
			Match what is
		*default (in	required by your	Must be disabled for OAI.
		example file)	PBX. See RFC2833.
			See config file
			example for more
			information.
PROXYn_KEYPRESS_INFO	enable		Controls generation	n = 1, 2, 3
		disable	of SIP INFO requests
			to the SIP server for	Must be enabled for OAI.
			keypress events.
			Normally enabled.

PN: 1725-36034-001_C.doc 47