Alliance Laundry Systems CI 2050/325, CI 1650/325 instruction manual Air filters, Exhaust gases

Page 23

3

Air filters

Before operating the machine, the air filter(s) must be checked.

By removing the right door, you can check if the filter on the venturi of the gas valve is not blocked by something.

Important

Do not cover this filter at any time!

Exhaust gases

The exhaust gases of a gas-heated ironer must be inspected by an authorized mechanic. The gas burner needs to be adjusted at prevailing rules, gas sort and gas pressure.

The measured exhaust gases may not be higher than the current rules.

Check the exhaust pipe on leaks and repair this, if so.

23

Image 23

Contents September Part No. D1273Page Contents Explanation of Safety Messages Safety InformationPage Safety notice Important Safety Instructions Page Intended use Product descriptionDescription of structural components Workplaces and noise level 1650/325 2050/325 Technical data CI1650/325, CI2050/325Sound level measurement Warranty and service instructions Transport and machine fastening Initial setup of the machine30 cm Setting up the machinePage Page Page 16A Page Ventilation of the room Basic checksExhaust gases Air filtersOperating devices and their position OperationStarting the machine Pedal Set the iron temperatureFunctions Set the ironing speedEnding Return button not with guiding ribbonsFailure and information signals Page Page Page Feeding sheets and towels Machine function, adjustment and troubleshootingDescription of machine functions General description of machine functionOperating the foot pedal option Advice Setting the temperatureSetting the speed Manual drive Guiding ironing belts Adjustments of the machineTightening the drive chain Tightening the ironing belts Tightening the feeding belts Adjusting the gap between input table and main roll Fault Condition Possible cause TroubleshootingFault Cause Remedy Fault Condition Solution After resetElectric heating control Temperature controlDescription of the control system General description of the control systemStart/stop function Control of exhaust ventilatorSpeed control Control panel and function keys Manual version Menu structure and how to enterMenu structure Manu adjusting menu Coin adjusting menu C2L coin 2 low Add XX defaultC1M coin 1 Medium C1H coin 1 HighTechnical menu Start PWM default Kp Xxxx default gas 300 default elecKd Xxxx default gas 1000 default elec Ki Xxxx default gas 0.5 default elecTMP REv Y/n default YES not adjustable with coinDiSP Display menuCentral panel Sigma explorerDaily maintenance MaintenanceSafety advice Maintenance schemeMonthly maintenance Weekly maintenancePage Page Half-yearly maintenance Feeding belts Drive Ironer beltsScrapers