Alliance Laundry Systems CI 2050/325, CI 1650/325 instruction manual Scrapers

Page 63

7

Scrapers

Check if the scrapers are damaged. If one of the fingers of the scrapers has become bent, you have to exchange the scraper.

Slacken the scraper beam by loosening the fixing bolt (1x left and 1x right). Now the beam can be turned so that the fastening screws of the scraper plates become visible. A scraper plate is fastened with 5 screws.

The scrapers are fitted with plastic blocks. These blocks run over the ironing roller and will wear.

Check these blocks on wear. If this wear is to such an extend that the metal of the scraper almost pierces the plastic, this plastic block has to be exchanged.

scraper

63

Image 63

Contents September Part No. D1273Page Contents Explanation of Safety Messages Safety InformationPage Safety notice Important Safety Instructions Page Intended use Product descriptionDescription of structural components Workplaces and noise level 1650/325 2050/325 Technical data CI1650/325, CI2050/325Sound level measurement Warranty and service instructions Transport and machine fastening Initial setup of the machine30 cm Setting up the machinePage Page Page 16A Page Ventilation of the room Basic checksExhaust gases Air filtersOperating devices and their position OperationStarting the machine Pedal Set the iron temperatureFunctions Set the ironing speedEnding Return button not with guiding ribbonsFailure and information signals Page Page Page Feeding sheets and towels Machine function, adjustment and troubleshootingDescription of machine functions General description of machine functionOperating the foot pedal option Advice Setting the temperatureSetting the speed Manual drive Guiding ironing belts Adjustments of the machineTightening the drive chain Tightening the ironing belts Tightening the feeding belts Adjusting the gap between input table and main roll Troubleshooting Fault Cause RemedyFault Condition Possible cause Fault Condition Solution After resetElectric heating control Temperature controlDescription of the control system General description of the control systemControl of exhaust ventilator Speed controlStart/stop function Control panel and function keys Manual version Menu structure and how to enterMenu structure Manu adjusting menu Coin adjusting menu C2L coin 2 low Add XX defaultC1M coin 1 Medium C1H coin 1 HighTechnical menu Start PWM default Kp Xxxx default gas 300 default elecKd Xxxx default gas 1000 default elec Ki Xxxx default gas 0.5 default elecTMP REv Y/n default YES not adjustable with coinDiSP Display menuCentral panel Sigma explorerDaily maintenance MaintenanceSafety advice Maintenance schemeMonthly maintenance Weekly maintenancePage Page Half-yearly maintenance Feeding belts Drive Ironer beltsScrapers