Alliance Laundry Systems CI 1650/325, CI 2050/325 instruction manual Tightening the drive chain

Page 38

5

Tightening the drive chain

A chain drives the machine. In the course of time, this chain will extend. It is important that the chain’s tension is checked every month. You can check the chain’s tension by moving the left part of the chain, at half-height, to the left and the right.

The total motion of freedom of the chain may horizontally not be more than 30mm. If it is more than 30mm, you have to tighten the chain. This can be done by slackening the four bolts B (see B on the picture below) a few turns. By doing so, the motor becomes loose and it will move downwards.

If the motor is not moving downwards by itself, you can do this by hand. After that, screw the four bolts B again. Check the chain tension once again. Repeat the procedure, if necessary.

Never tighten the chain too much.

WARNING

Only do this when the machine has been stopped, cooled down and the main switch has been locked in position "0".

38

Image 38

Contents Part No. D1273 SeptemberPage Contents Safety Information Explanation of Safety MessagesPage Safety notice Important Safety Instructions Page Product description Intended useDescription of structural components Workplaces and noise level Technical data CI1650/325, CI2050/325 1650/325 2050/325Sound level measurement Warranty and service instructions Initial setup of the machine Transport and machine fasteningSetting up the machine 30 cmPage Page Page 16A Page Basic checks Ventilation of the roomAir filters Exhaust gasesOperation Operating devices and their positionStarting the machine Set the ironing speed Set the iron temperatureFunctions PedalReturn button not with guiding ribbons EndingFailure and information signals Page Page Page General description of machine function Machine function, adjustment and troubleshootingDescription of machine functions Feeding sheets and towelsOperating the foot pedal option Setting the temperature AdviceSetting the speed Manual drive Adjustments of the machine Guiding ironing beltsTightening the drive chain Tightening the ironing belts Tightening the feeding belts Adjusting the gap between input table and main roll Fault Condition Possible cause TroubleshootingFault Cause Remedy After reset Fault Condition SolutionGeneral description of the control system Temperature controlDescription of the control system Electric heating controlStart/stop function Control of exhaust ventilatorSpeed control Control panel and function keys Menu structure and how to enter Manual versionMenu structure Manu adjusting menu Coin adjusting menu C1H coin 1 High Add XX defaultC1M coin 1 Medium C2L coin 2 lowTechnical menu Ki Xxxx default gas 0.5 default elec Kp Xxxx default gas 300 default elecKd Xxxx default gas 1000 default elec Start PWM defaultREv Y/n default YES not adjustable with coin TMPSigma explorer Display menuCentral panel DiSPMaintenance scheme MaintenanceSafety advice Daily maintenanceWeekly maintenance Monthly maintenancePage Page Half-yearly maintenance Feeding belts Ironer belts DriveScrapers