Alliance Laundry Systems CI 2050/325, CI 1650/325 Control of exhaust ventilator, Speed control

Page 45

6

Control of exhaust ventilator

The exhaust ventilator always turns on maximum when the ironer is switched on. An underpressure switch is mounted, which controls the working of the exhaust ventilator. The function of this underpressure switch is controlled when starting up the machine and will give a warning sign when the function is not correct.

Speed control

The speed is controlled by means of a frequency regulator, which is controlled by a feedback system through the microprocessor board.

The speed is checked by an approximated switch, which is activated by the teeth of a detection wheel.

teeth of a detection wheel

approximated switch

Start/stop function

The ironer can be started and stopped by pressing the 0/I button.

The foot pedal can temporarily stop the ironer.

45

Image 45

Contents September Part No. D1273Page Contents Explanation of Safety Messages Safety InformationPage Safety notice Important Safety Instructions Page Intended use Product descriptionDescription of structural components Workplaces and noise level 1650/325 2050/325 Technical data CI1650/325, CI2050/325Sound level measurement Warranty and service instructions Transport and machine fastening Initial setup of the machine30 cm Setting up the machinePage Page Page 16A Page Ventilation of the room Basic checksExhaust gases Air filtersOperating devices and their position OperationStarting the machine Functions Set the iron temperatureSet the ironing speed PedalEnding Return button not with guiding ribbonsFailure and information signals Page Page Page Description of machine functions Machine function, adjustment and troubleshootingGeneral description of machine function Feeding sheets and towelsOperating the foot pedal option Advice Setting the temperatureSetting the speed Manual drive Guiding ironing belts Adjustments of the machineTightening the drive chain Tightening the ironing belts Tightening the feeding belts Adjusting the gap between input table and main roll Troubleshooting Fault Cause RemedyFault Condition Possible cause Fault Condition Solution After resetDescription of the control system Temperature controlGeneral description of the control system Electric heating controlControl of exhaust ventilator Speed controlStart/stop function Control panel and function keys Manual version Menu structure and how to enterMenu structure Manu adjusting menu Coin adjusting menu C1M coin 1 Medium Add XX defaultC1H coin 1 High C2L coin 2 lowTechnical menu Kd Xxxx default gas 1000 default elec Kp Xxxx default gas 300 default elecKi Xxxx default gas 0.5 default elec Start PWM defaultTMP REv Y/n default YES not adjustable with coinCentral panel Display menuSigma explorer DiSPSafety advice MaintenanceMaintenance scheme Daily maintenanceMonthly maintenance Weekly maintenancePage Page Half-yearly maintenance Feeding belts Drive Ironer beltsScrapers