Alliance Laundry Systems CI 2050/325 Adjustments of the machine, Guiding ironing belts

Page 37

5

Adjustments of the machine

Guiding ironing belts

The ironing belts are guided by plates on a beam, which is placed between the ironing belts. On the outlet side, a beam, which has a fixed position, guides these ironing belts

(see 1 on the picture below).

There is also a beam on the back side of the machine (see 2 on the picture below).

If the guiding of the ironing belts is not adjusted correctly, it will effect the life of the ironing belts in a negative way. If the ironing belts have been dismounted/replaced, you have to recheck the guiding of the ironing belts. Beam 2 can be reached if you remove the plating on the rear side of the machine.

37

Image 37

Contents September Part No. D1273Page Contents Explanation of Safety Messages Safety InformationPage Safety notice Important Safety Instructions Page Intended use Product descriptionDescription of structural components Workplaces and noise level 1650/325 2050/325 Technical data CI1650/325, CI2050/325Sound level measurement Warranty and service instructions Transport and machine fastening Initial setup of the machine30 cm Setting up the machinePage Page Page 16A Page Ventilation of the room Basic checksExhaust gases Air filtersOperating devices and their position OperationStarting the machine Functions Set the iron temperatureSet the ironing speed PedalEnding Return button not with guiding ribbonsFailure and information signals Page Page Page Description of machine functions Machine function, adjustment and troubleshootingGeneral description of machine function Feeding sheets and towelsOperating the foot pedal option Advice Setting the temperatureSetting the speed Manual drive Guiding ironing belts Adjustments of the machineTightening the drive chain Tightening the ironing belts Tightening the feeding belts Adjusting the gap between input table and main roll Fault Cause Remedy TroubleshootingFault Condition Possible cause Fault Condition Solution After resetDescription of the control system Temperature controlGeneral description of the control system Electric heating controlSpeed control Control of exhaust ventilatorStart/stop function Control panel and function keys Manual version Menu structure and how to enterMenu structure Manu adjusting menu Coin adjusting menu C1M coin 1 Medium Add XX defaultC1H coin 1 High C2L coin 2 lowTechnical menu Kd Xxxx default gas 1000 default elec Kp Xxxx default gas 300 default elecKi Xxxx default gas 0.5 default elec Start PWM defaultTMP REv Y/n default YES not adjustable with coinCentral panel Display menuSigma explorer DiSPSafety advice MaintenanceMaintenance scheme Daily maintenanceMonthly maintenance Weekly maintenancePage Page Half-yearly maintenance Feeding belts Drive Ironer beltsScrapers