Alliance Laundry Systems CI 2050/325, CI 1650/325 Weekly maintenance, Monthly maintenance

Page 57

7

Weekly maintenance

Waxing

To prevent laundry from adhering to the ironing roller and to avoid corrosion of the ironing roller, this roller has to be "waxed“ every week. Follow the instructions below.

Important

Only use a normal sheet or table-cloth for a grease cloth.

Set the machine to 150°C and with a speed of 1.6 mtr. per minute. Take a grease cloth and check its state. If the grease cloth has sufficient wax, you can feed the cloth. The width of the grease cloth has to be equal to the width of the feeding conveyor, otherwise, the ironing roller will not be fully waxed.

If the machine is not going to be used for a longer period, you have to wax the ironing roller.

With this waxing, you can prevent the ironing roller from being corroded during this particular period.

Monthly maintenance

Fan

The vapour exhaust fan on the left side of the machine will become filthy during operation. Check the fan on this. By removing the left door, you can see the suction opening of the fan. Any filth accumulation is to be found in the impeller of the fan. Remove this by means of the vacuum cleaner.

While cleaning this part, do not forget to clean the frame space.

fan	fan impeller

57

Image 57

Contents September Part No. D1273Page Contents Explanation of Safety Messages Safety InformationPage Safety notice Important Safety Instructions Page Intended use Product descriptionDescription of structural components Workplaces and noise level 1650/325 2050/325 Technical data CI1650/325, CI2050/325Sound level measurement Warranty and service instructions Transport and machine fastening Initial setup of the machine30 cm Setting up the machinePage Page Page 16A Page Ventilation of the room Basic checksExhaust gases Air filtersOperating devices and their position OperationStarting the machine Functions Set the iron temperatureSet the ironing speed PedalEnding Return button not with guiding ribbonsFailure and information signals Page Page Page Description of machine functions Machine function, adjustment and troubleshootingGeneral description of machine function Feeding sheets and towelsOperating the foot pedal option Advice Setting the temperatureSetting the speed Manual drive Guiding ironing belts Adjustments of the machineTightening the drive chain Tightening the ironing belts Tightening the feeding belts Adjusting the gap between input table and main roll Troubleshooting Fault Cause RemedyFault Condition Possible cause Fault Condition Solution After resetDescription of the control system Temperature controlGeneral description of the control system Electric heating controlControl of exhaust ventilator Speed controlStart/stop function Control panel and function keys Manual version Menu structure and how to enterMenu structure Manu adjusting menu Coin adjusting menu C1M coin 1 Medium Add XX defaultC1H coin 1 High C2L coin 2 lowTechnical menu Kd Xxxx default gas 1000 default elec Kp Xxxx default gas 300 default elecKi Xxxx default gas 0.5 default elec Start PWM defaultTMP REv Y/n default YES not adjustable with coinCentral panel Display menuSigma explorer DiSPSafety advice MaintenanceMaintenance scheme Daily maintenanceMonthly maintenance Weekly maintenancePage Page Half-yearly maintenance Feeding belts Drive Ironer beltsScrapers