Alliance Laundry Systems CI 2050/325, CI 1650/325 Product description, Intended use

Page 9

2

Product description

Intended use

The machine, described in this manual is solely intended to use it for ironing of sheets, small pieces of linen, pillowcases, table linen and other flat linen.

It is not suitable for garments or other thick linen.

WARNING

Any other use of the machine may involve risks to persons and must therefore only take place after previously obtained written approval from the manufacturer.

Equipment and components on the machine, which are important to safety and health, have been constructed in preparation for an expected life of 15,000 operating hours - however max. 10 years from the time of manufacture.

WARNING

The correct function of such equipment and components within this period implies that the prescribed maintenance is carried out.

Normally the ironed pieces are coming into the outlet tray after ironing, where the operator can take them without any danger.

WARNING

It may involve risk of burning to the operator when taking the sheets directly from the roll, deeper into the machine at the outlet tray. Jams should always be taken away by authorized personnel.

The normal, permanent working places of the operating personnel (operator) have been marked on the layout.

WARNING

It may involve risk to the operator to work on or under the machine. Work Stay in these areas is only allowed for authorized personnel, and only when the machine has been stopped, cooled down and the main switch has been locked in position "0".

Important

This manual is a part of the delivered machine volume, and is to be handed over to the new owner if the machine is sold.

If any doubt should occur about the contents in the manuals in your local language, which you should have received at the time the machine was first installed, it will always be the English text, which is valid.

9

Image 9
Contents September Part No. D1273Page Contents Explanation of Safety Messages Safety InformationPage Safety notice Important Safety Instructions Page Intended use Product descriptionDescription of structural components Workplaces and noise level 1650/325 2050/325 Technical data CI1650/325, CI2050/325Sound level measurement Warranty and service instructions Transport and machine fastening Initial setup of the machine30 cm Setting up the machinePage Page Page 16A Page Ventilation of the room Basic checksExhaust gases Air filtersOperating devices and their position OperationStarting the machine Functions Set the iron temperatureSet the ironing speed PedalEnding Return button not with guiding ribbonsFailure and information signals Page Page Page Description of machine functions Machine function, adjustment and troubleshootingGeneral description of machine function Feeding sheets and towelsOperating the foot pedal option Advice Setting the temperatureSetting the speed Manual drive Guiding ironing belts Adjustments of the machineTightening the drive chain Tightening the ironing belts Tightening the feeding belts Adjusting the gap between input table and main roll Troubleshooting Fault Cause RemedyFault Condition Possible cause Fault Condition Solution After resetDescription of the control system Temperature controlGeneral description of the control system Electric heating controlControl of exhaust ventilator Speed controlStart/stop function Control panel and function keys Manual version Menu structure and how to enterMenu structure Manu adjusting menu Coin adjusting menu C1M coin 1 Medium Add XX defaultC1H coin 1 High C2L coin 2 lowTechnical menu Kd Xxxx default gas 1000 default elec Kp Xxxx default gas 300 default elecKi Xxxx default gas 0.5 default elec Start PWM defaultTMP REv Y/n default YES not adjustable with coinCentral panel Display menuSigma explorer DiSPSafety advice MaintenanceMaintenance scheme Daily maintenanceMonthly maintenance Weekly maintenancePage Page Half-yearly maintenance Feeding belts Drive Ironer beltsScrapers