Alliance Laundry Systems CI 2050/325, CI 1650/325 instruction manual Initial setup of the machine

Page 15

3

Initial setup of the machine

Transport and machine fastening

The machine has been secured with bolts on a solid wooden frame and has been safely packed in plastic sheeting from the factory.

WARNING / DANGER

During all transport and handling of the machine, there is a risk of the machine tipping over or falling over onto persons. In order to avoid accidents, the following should therefore be observed:

During transport and handling with a fork-lift truck, the forks should be situated proportional to the center of gravity as shown below and on the packing of the machine.

Never use lifting and hoisting material with a too small lifting capacity. See paragraph 'Technical data' concerning the weight of the machine.

The max. weight of the machine including packing is stated on the packing of the machine.

Never move the machine on inclined or uneven surfaces.

Important

We recommend to let the wooden frame remain bolted for the use of transport with fork-lift truck, until the machine is near the place of setting up.

15

Image 15

Contents September Part No. D1273Page Contents Explanation of Safety Messages Safety InformationPage Safety notice Important Safety Instructions Page Intended use Product descriptionDescription of structural components Workplaces and noise level 1650/325 2050/325 Technical data CI1650/325, CI2050/325Sound level measurement Warranty and service instructions Transport and machine fastening Initial setup of the machine30 cm Setting up the machinePage Page Page 16A Page Ventilation of the room Basic checksExhaust gases Air filtersOperating devices and their position OperationStarting the machine Pedal Set the iron temperatureFunctions Set the ironing speedEnding Return button not with guiding ribbonsFailure and information signals Page Page Page Feeding sheets and towels Machine function, adjustment and troubleshootingDescription of machine functions General description of machine functionOperating the foot pedal option Advice Setting the temperatureSetting the speed Manual drive Guiding ironing belts Adjustments of the machineTightening the drive chain Tightening the ironing belts Tightening the feeding belts Adjusting the gap between input table and main roll Troubleshooting Fault Cause RemedyFault Condition Possible cause Fault Condition Solution After resetElectric heating control Temperature controlDescription of the control system General description of the control systemControl of exhaust ventilator Speed controlStart/stop function Control panel and function keys Manual version Menu structure and how to enterMenu structure Manu adjusting menu Coin adjusting menu C2L coin 2 low Add XX defaultC1M coin 1 Medium C1H coin 1 HighTechnical menu Start PWM default Kp Xxxx default gas 300 default elecKd Xxxx default gas 1000 default elec Ki Xxxx default gas 0.5 default elecTMP REv Y/n default YES not adjustable with coinDiSP Display menuCentral panel Sigma explorerDaily maintenance MaintenanceSafety advice Maintenance schemeMonthly maintenance Weekly maintenancePage Page Half-yearly maintenance Feeding belts Drive Ironer beltsScrapers