Alliance Laundry Systems CI 1650/325, CI 2050/325 instruction manual

Page 58

7

Filter gas mixture

Check filter on dust. Clean if dirty.

Frame right side

This space has to be cleaned every month (also gas-heated ironers).

Vapour exhaust beam

As a result of the laundry being ironed, dust will remain in the machine. This dust accumulates at a certain number of places. One place is the vapour exhaust beam on top of the machine.

By removing the left door of the machine, you can see the vapour exhaust beam. Shine with an electric torch through the hole at the left on top of the left side frame. Here, you can see the internal pollution of the vapour exhaust beam.

If this is seriously polluted, you can open the top and clean it.

Important

If the inside of the beam is clean, it will not guarantee that the bottom and the outside of the vapour exhaust beam are clean. Therefore, open the top and check it each month thoroughly.

58

Image 58

Contents Part No. D1273 SeptemberPage Contents Safety Information Explanation of Safety MessagesPage Safety notice Important Safety Instructions Page Product description Intended useDescription of structural components Workplaces and noise level Technical data CI1650/325, CI2050/325 1650/325 2050/325Sound level measurement Warranty and service instructions Initial setup of the machine Transport and machine fasteningSetting up the machine 30 cmPage Page Page 16A Page Basic checks Ventilation of the roomAir filters Exhaust gasesOperation Operating devices and their positionStarting the machine Set the ironing speed Set the iron temperatureFunctions PedalReturn button not with guiding ribbons EndingFailure and information signals Page Page Page General description of machine function Machine function, adjustment and troubleshootingDescription of machine functions Feeding sheets and towelsOperating the foot pedal option Setting the temperature AdviceSetting the speed Manual drive Adjustments of the machine Guiding ironing beltsTightening the drive chain Tightening the ironing belts Tightening the feeding belts Adjusting the gap between input table and main roll Fault Cause Remedy TroubleshootingFault Condition Possible cause After reset Fault Condition SolutionGeneral description of the control system Temperature controlDescription of the control system Electric heating controlSpeed control Control of exhaust ventilatorStart/stop function Control panel and function keys Menu structure and how to enter Manual versionMenu structure Manu adjusting menu Coin adjusting menu C1H coin 1 High Add XX defaultC1M coin 1 Medium C2L coin 2 lowTechnical menu Ki Xxxx default gas 0.5 default elec Kp Xxxx default gas 300 default elecKd Xxxx default gas 1000 default elec Start PWM defaultREv Y/n default YES not adjustable with coin TMPSigma explorer Display menuCentral panel DiSPMaintenance scheme MaintenanceSafety advice Daily maintenanceWeekly maintenance Monthly maintenancePage Page Half-yearly maintenance Feeding belts Ironer belts DriveScrapers