Alliance Laundry Systems CI 2050/325, CI 1650/325 Menu structure and how to enter, Manual version

Page 47

6

Menu structure and how to enter

After installation, each ironer needs to be configured.

There are 2 different systems: Manual and Coin version.

Manual version

When the main switch is switched on, " " appears on the right display during 5 seconds.

To enter the adjusting menus, press the I/0 button and ↓ button simultaneously until " " appears on

the right display. With the + and - button, it is possible to switch between the menus , and

. By pressing the ↓ button, you choose a specific menu.

5 sec

I/0 +

I

- +- +

+ -

Coin version: hidden buttons

The hidden buttons (A) normally have no function in the coin version.

However, during the configuration, they have the same function as the manual version.

A

47

Image 47

Contents September Part No. D1273Page Contents Explanation of Safety Messages Safety InformationPage Safety notice Important Safety Instructions Page Intended use Product descriptionDescription of structural components Workplaces and noise level 1650/325 2050/325 Technical data CI1650/325, CI2050/325Sound level measurement Warranty and service instructions Transport and machine fastening Initial setup of the machine30 cm Setting up the machinePage Page Page 16A Page Ventilation of the room Basic checksExhaust gases Air filtersOperating devices and their position OperationStarting the machine Pedal Set the iron temperatureFunctions Set the ironing speedEnding Return button not with guiding ribbonsFailure and information signals Page Page Page Feeding sheets and towels Machine function, adjustment and troubleshootingDescription of machine functions General description of machine functionOperating the foot pedal option Advice Setting the temperatureSetting the speed Manual drive Guiding ironing belts Adjustments of the machineTightening the drive chain Tightening the ironing belts Tightening the feeding belts Adjusting the gap between input table and main roll Fault Condition Possible cause TroubleshootingFault Cause Remedy Fault Condition Solution After resetElectric heating control Temperature controlDescription of the control system General description of the control systemStart/stop function Control of exhaust ventilatorSpeed control Control panel and function keys Manual version Menu structure and how to enterMenu structure Manu adjusting menu Coin adjusting menu C2L coin 2 low Add XX defaultC1M coin 1 Medium C1H coin 1 HighTechnical menu Start PWM default Kp Xxxx default gas 300 default elecKd Xxxx default gas 1000 default elec Ki Xxxx default gas 0.5 default elecTMP REv Y/n default YES not adjustable with coinDiSP Display menuCentral panel Sigma explorerDaily maintenance MaintenanceSafety advice Maintenance schemeMonthly maintenance Weekly maintenancePage Page Half-yearly maintenance Feeding belts Drive Ironer beltsScrapers