NordicTrack NTL11920 user manual Troubleshooting, Problem The power turns off during use, Solution

Page 26

TROUBLESHOOTING

Most treadmill problems can be solved by following the steps below. Find the symptom that applies, and follow the steps listed. If further assistance is needed, please call our Customer Service Department toll-

free at 1-888-825-2588, Monday through Friday, 6 a.m. until 6 p.m. Mountain Time (excluding holidays).

PROBLEM: The power does not turn on

SOLUTION: a. Make sure that the power cord is plugged into a surge suppressor, and that the surge suppressor

is plugged into a properly grounded outlet (see page 8). Use only a single-outlet surge suppressor that meets all of the specifications described on page 8. Important: The treadmill is not compatible with GFCI-equipped outlets.

b. After the power cord has been plugged in, make sure that the key is fully inserted into the console.

c. Check the circuit breaker located on the treadmill

 

 

 

 

 

c

 

near the power cord. If the switch protrudes as

 

 

 

 

 

 

shown, the circuit breaker has tripped. To reset the

 

 

 

 

circuit breaker, wait for five minutes and then press

 

 

 

 

the switch back in.

 

 

Tripped

 

 

 

 

 

 

 

 

 

 

PROBLEM: The power turns off during use

Reset

SOLUTION: a. Check the circuit breaker located on the treadmill frame near the power cord (see c. above). If the circuit breaker has tripped, wait for five minutes and then press the switch back in.

b. Make sure that the power cord is plugged in. If the power cord is plugged in, unplug it, wait for five minutes, and then plug it back in.

c. Remove the key from the console. Reinsert the key fully into the console.

e. If the treadmill still will not run, please call our Customer Service Department, toll-free.

PROBLEM: The displays of the console do not function properly

SOLUTION:

a. Remove the key from the console and

unplug the

 

power cord.

Carefully tip the treadmill down as shown

 

in drawing a. Remove the 1” Screws (33)

and 2”

 

Screws (3) from the hood. Raise the Uprights (69) and

 

carefully remove the hood.

 

Locate the Reed Switch (10) and the Magnet (7) on

 

the left side of the Pulley (8). Turn the Pulley until the

 

Magnet is aligned with the Reed Switch.

Make sure

that the gap between the Magnet and the Reed

 

Switch is about 1/8”.

If necessary, loosen the Screw

(27)and move the Reed Switch slightly. Retighten the Screw. Re-attach the hood, making sure the screw are in their same holes. Run the treadmill for a few min- utes to check for a correct speed reading.

a

 

 

33

 

3

69

 

1/8”

8

27

 

10

7

Top

 

View

 

26

Page 25 Page 27
Image 26
Page 25 Page 27
Contents QUESTIONS? Customer HOT LineTable of Contents Important Precautions Never insert or drop any object into any opening Left Side Using the treadmillBefore YOU Begin Right SideYour own phillips screwdriver Wire cutters AssemblyAssembly requires two people Extension Legs 102 remain in the UprightsTighten all four Handrail Bolts Be careful not to pinch the WiresDo not tighten the Bolts yet Clear plastic on the hood decal, remove it. KHOW to Plug in the Power Cord Performant LubeFollow Features of the ConsolePulse Sensor Clip SeeHOW to Turn on the Power HOW to USE the Manual ModeIncline/Heart Rate Display Follow your progress with the displaysDisplay Distance/Laps DisplayFor HOW to USE Preset ProgramsAvoid Moving your Hands 7Turn on the fans if desiredMeasure your heart rate if desired Stop button, remove the key, and then reinsert the keySee on Cline of the treadmill is at the lowest levelPress the Start button or the Speed + button HOW to Create Custom ProgramsWhen the program has ended, remove the key To decrease HOW to USE Custom ProgramsSelect one of the custom programs Select a heart rate program 1Put on the chest pulse sensorInsert the key fully into the console Enter your age7Follow your progress with the displays When the program is completed, remove Key from the consoleIf your pulse is not detected during the program Videocassettes HOW to Connect Your Portable CD PlayerHOW to Connect Your Portable Stereo Plug the adapter into the Line OUT jack on your stereo HOW to Connect Your Home StereoHOW to Connect Your Computer Phones jack, see instruction BHOW to Connect Your VCR ProgramsStart button or the Speed Next settings of the CD or video program7When the program has ended, remove the key ConsoleFollow the on-line instructions to start Program HOW to USE Programs Directly from OUR WEB SiteNext settings of the program Optional Chest Pulse Sensor Information MODE/DEMO ModeHOW to Adjust the Cushioning System HOW to Fold the Treadmill for Storage HOW to Move the TreadmillHOW to Lower the Treadmill for USE Hold the treadmill firmly with both hands, and lowerSolution TroubleshootingProblem The power turns off during use Power cordIf the walking belt has Problem The walking belt slows when walked onPower Cord Shifted to the leftWorkout Guidelines Conditioning GuidelinesExercise Intensity Exercise FrequencySuggested Stretches Description 116 Right Cup Holder Black Wire, 2F 117 Left Inside Housing Ordering Replacement Parts109 Power Cord Grommet 129 Gear Rack 110 Frame 130 105 Transformer 125Part No R1102B Limited WarrantyWhat is COVERED-The entire NordicTrack Icon Health & FITNESS, INC., 1500 S W., LOGAN, UTExploded R1102BExploded DRAWING-Model No. NTL11920
Top Page Image Contents