NordicTrack 9800 user manual HOW to Reset the Lube Reminder

Page 25

The console will begin scanning all TV channels. If no broadcast signal is detected on a channel, the channel will be skipped; if a signal is detected, a tone will sound and the channel will be stored in memory. This process will continue until the high- est channel is reached. The lowest channel stored in memory will then appear in the main display.

Press the ENTER AGE button again and delete or add TV channels.

After all valid TV channels have been stored in the console’s memory, you can delete unwanted channels or add other channels. To delete or add a channel, first press the CHANNEL + and – but- tons until the channel appears in the main display.

If the word DELETE appears beside the channel, press the + or – button beside the ENTER AGE button to delete the channel. If the word ADD ap- pears beside the channel, press the + or – button beside the ENTER AGE button to add the chan- nel. Then, select the next channel that you want to delete or add. Repeat this process until you have finished deleting or adding channels.

Hold down the ENTER AGE button and the RESET button simultaneously for two seconds to exit the maintenance mode.

To exit the maintenance mode at any time, hold down the ENTER AGE button and the RESET but- ton simultaneously for two seconds.

HOW TO RESET THE LUBE REMINDER

If the words LUBRICATE DECK appear in the main display when the maintenance mode is selected (refer to step 9 on page 23), follow the steps below to reset the lube reminder.

Insert the key into the console.

Refer to GETTING STARTED on page 14.

Hold down the STOP button and the RESET button simultaneously for three seconds.

24

Image 25
Contents Model No Serial No QUESTIONS?Table of Contents Page Trainer Important PrecautionsIncline Trainer Page Hazardous Voltage Before YOU Begin Avoid pinching the wires in the Handrail HOW to SET UP the Incline TrainerSure that the Uprights are on the correct sides Indicated holes must be facing the InclineUpright Cap Screws Upright Bolts yetDue to the size and weight of the Incline HOW to Move the Incline TrainerTRAINER, moving it requires two persons. While HOW to Connect the Power Cord HOW to Connect the Incline TrainerHOW to Connect a Catv Cable HOW to Upgrade Your Console Page Features of the Console HOW to USE the Basic ConsoleGetting Started Select the manual mode HOW to USE the Manual ModeChange the incline of the Incline Trainer as desired On the foot rails Measure your heart rate if desiredAvoid moving Shown. For the most accurate heart rate readSelect one of the six preset programs HOW to USE Preset ProgramsPage Select one of the three pulse-driven programs HOW to USE PULSE-DRIVEN ProgramsSelect the fitness test program HOW to USE the Fitness Test ProgramPress the Start button to start the program HOW to USE the Maintenance Mode Press the Enter AGE button again and program TV channels Press the Enter AGE button again to check for system errorsHOW to Reset the Lube Reminder HOW to USE the Workout TV Console Put on headphones not included if desired HOW to USE the Workout TV ConsoleAdjust the volume Weekly Maintenance Preventive MaintenanceMonthly Maintenance Remove the key and unplug Turning the Walking PlatformReplacing the Walking Platform Replacing the Walking BeltWeekly Maintenance Monthly Maintenance SIX-MONTH Preventive Maintenance RecordWalking Platform Turned/Replaced Walking Belt Replaced SIX-MONTH Preventive Maintenance Record Symptom the Power does not Turn on TroubleshootingSymptom the Power Turns OFF During USE Symptom the Walking Belt Slows When Walked onPage Factors in a Sensible Diet Exercise GuidelinesExercise Steps Target Heart Rate ZonesWarm up before you begin Weight Loss TipsStretch after your warm-up Get FIT with NordicTrack Benefits of Aerobic ExerciseCool down after aerobic exercise Stretch again at the end of your exercise sessionWorkout Programs Workout TipsKey No. Qty. Description Part ListKey Qty Description Part 1 Exploded DrawingPart 2 3of 140 Part 142 HOW to Order Replacement Parts