Precor M9.33 manual Clearing the Settings on a Custom Program

During the program, the TIME display relates to the amount of time remaining in the recorded columns. Total elapsed time appears when you record new columns.

Note: The length of the custom program and number of speed and incline settings are limited to the available memory in the treadmill. The program will not end if the available memory is exhausted, but the display notifies you, and

further changes to speed or incline are not saved. Approximately six hours of recording time is available for the two user IDs.

Clearing the Settings on a Custom Program

Perform the following steps to clear (delete) any speed or incline settings stored in a custom program.

1.At the Precor banner, press USER 1 or USER 2, and then press ENTER.

2.Use any arrow key to specify the custom program (CST1 or CST2) that you wish to clear.

Important: Clearing the speed and incline settings from a custom program permanently deletes them from memory.

3.While the program name is blinking, press and hold the SELECT key associated with the user ID specified earlier for ten seconds. After the message CLEARED appears on the display, you can release the key. Speed and incline information are rest to zero.

Note: During the 10-second delay, you can release the SELECT key and no change will occur to the custom program settings.

Owner’s Manual: Programs 36