Precor M9.33 manual Checking the Alignment and Adjusting the Running Belt

Page 65

Checking the Alignment and Adjusting the Running Belt

Proper belt alignment allows the belt to remain centered and ensures smooth operation. Realigning the belt takes a few simple adjustments. If you are unsure about this procedure, call Precor Customer Support at 1-800-347-4404.

To check the alignment:

1.The treadmill has adjustable rear feet. Make sure that the running surface is level. If the treadmill is placed on an uneven surface, adjusting the rear feet can help, but will not compensate for extremely uneven surfaces.

Important: Do not raise or lower the unit beyond 2 centimeters (¾ inch). Check the level of the unit after each adjustment.

2.Turn the unit ON.

3.Stand beside the treadmill and press QUICKSTART.

4.If you are prompted for a password, press

INCLINE ▼, SPEED ▼, SPEED ▲. The running belt starts automatically after the 3-second countdown appears on the display.

5.Press the SPEED s key until the display shows a speed of 3 mph (5 kph).

6.Walk around to the rear of the unit and observe the belt for a few minutes. The belt should run centered along the running bed. If the belt drifts off center, you will need to make adjustments.

Important: If the belt needs alignment, make the adjustments immediately after turning the treadmill OFF. Failure to do so may cause the belt to tear or fray, which is not covered by the Precor Limited Warranty.

7.To stop the running belt, press the red STOP button.

8.Turn the treadmill OFF.

To adjust the running belt:

CAUTION: To ensure your safety, turn OFF (O) the treadmill before making any adjustments.

1.Locate the right belt adjustment bolt in the rear end cap of the treadmill. (To determine left and right, stand at the rear of the treadmill and face the display.) Make all belt adjustments on the right rear corner bolt using the ¼-inch hex key.

•If the belt is off center to the LEFT, turn the adjusting bolt ¼ turn

counterclockwise, which moves the running belt to the right.

• If the belt tracks off center to the RIGHT, turn the bolt ¼ turn clockwise; this moves the belt to the left.

Important: Do not turn the adjusting

bolt more than ¼ turn at a time. Overtightening the bolt can damage the treadmill.

2. Recheck the alignment of the running belt.

M9.3x Low-Impact Treadmills Assembly Guide

7

Page 64 Page 66
Image 65
Page 64 Page 66
Contents Page Page Important Safety Instructions Grounding Instructions Grounding Instructions Password SecuritySafety Approval Federal Communications Commission, Part Radio Frequency Interference RFIUnits Designated for U.S. Markets Débranchez avant de réparer European ApplicationsCanadian Department of Communications Obtaining Service Table of Contents Precor Residential Equipment Entering the Password Using the Security ClipTurning the Unit on and OFF Using the HandrailsGuidelines 114Using the Heart Rate Touch-Sensitive Grips Using SmartRate LED Exercise to Your Target Heart RateDisplay Console Page Keypad Scanning and the DisplayQuickstart Changing the Display Features Using the Select Key 1532 Precor Choosing Quickstart Selecting a User ID UserCST2 Selecting a ProgramCooling Down After a Workout Pausing During a Workout or the Cool-Down Period Ending a Workout Choosing a Program ProgramsTable below shows a variety of program options Program TipsManual Manl Program Walk WLK Programs ManlRun RUN Programs Interval Intv Program IntvRandom Rand Program RandWtls Weight Loss Wtls ProgramWarm-up Period Heart Rate Control HRC ProgramCustom CST1 or CST2 Programs Using the HRC ProgramClearing the Settings on a Custom Program Advanced Programming Tips Advanced Programming and TroubleshootingSelecting a U.S. Standard or Metric Display RESET, QUICKSTART, ENTER, Select User 2, InclineSelecting Password Protection Viewing the Odometer Informational DisplaysViewing the Hour Meter Viewing the Software Version and Part NumbersER33 AT 12,345,678 Miles 1,714 Hours Viewing the Error LogViewing the Serial Number Troubleshooting Error CodesRcvr Troubleshooting Heart RateInspection Cleaning the EquipmentChecking the Alignment Running Belt Storing the Chest StrapAdjusting the Running Belt Long-Term Storage Servicing the TreadmillOptions / Accessories Limited WarrantyWarranty Periods and Coverage Disclaimer and Release This limited warranty shall not apply toConditions and Restrictions Exclusion of Consequential and Incidental Damages Exclusive RemediesThank You and Welcome to Precor Tell US about Your NEW Precor Product Page M9.33 Low Impact Treadmill Product SpecificationsQUICKSTARTiTM Choose a Program Assembly Guide Required Tools Hardware Kit Assembly Steps Incline , Speed , Speed M9.3x Low-Impact Treadmills Assembly Guide Checking the Alignment and Adjusting the Running Belt Precor Incorporated 20031 142nd Avenue NE Box
Top Page Image Contents