Precor 9.35 manual Interior rail, Head or sustain other injuries if you ignore the location

Unwrap the cable and remove the kinks. Ask your assistant to hold the handrail extensions while you feed the cable inside the right upright support. Make sure the cable connector rests on the floor at the base of the upright support.

	CAUTION: Be aware of the handrail extensions when you are
Interior rail	working around the front of the unit. It is easy to bump your
	head or sustain other injuries if you ignore the location of the
	handrail extensions.

Have your assistant hold the handrail assembly above the upright supports. Tip the assembly forward so the mounting brackets slide along the interior rails inside the upright supports. Align the mounting holes and insert six buttonhead screws (B). For easier assembly, insert the top rear fasteners first. Then, lift the handrail extensions and insert the bottom front fasteners. Align the top front mounting holes and thread the two remaining fasteners. Finger tighten.

Important: Make sure the fasteners do not pinch the cable. Cables damaged by improper installation will not be covered by the Precor Limited Warranty.

Pull the cable connector through the hole in the right upright support.

Connect the display cable to its receptacle on the electronics board. The tab on the cable connector faces the front of the treadmill. An audible click is heard when the cable is properly attached.

Note: Place the excess cable inside the upright support.

Tighten all mounting screws.

a. Start at the base and use the ¼-inch hex key to alternately tighten the eight fasteners that secure the upright supports to the base assembly. Refer to steps 2 and 3.

b. Use the ³⁄₁₆-inch hex key to wrench tighten the six screws that secure the handrail extensions to the upright supports. Refer to step 5.

9.3x Low-Impact Treadmills Assembly Guide 4