Options, Location Requirements | Whirlpool FRONT-LOADING GAS DRYER

Options

Pedestal

Are you placing the dryer on a pedestal? You may purchase a pedestal separately for this dryer. This pedestal will add about 13" (33 cm) to the height of your unit for a total height of approximately 51" (130 cm).

For a garage installation, you will need to place the pedestal at least 6" (15.2 cm) above the floor.

Optional pedestal

To order, call the dealer from whom you purchased your dryer or refer to the “Assistance or Service” section of this manual. Ask for Part Number LAB2700PMT (Meteorite) or LAB2700MQ0 (White).

Stack Kit

Are you planning to stack your washer and dryer? To do so, you will need to purchase a Stack Kit.

To order, call the dealer from whom you purchased your dryer or refer to the “Assistance or Service” section of this manual. Ask for Part Number 8541503.

Location Requirements

WARNING

Explosion Hazard

Keep flammable materials and vapors, such as gasoline, away from dryer.

Place dryer at least 18 inches (46 cm) above the floor for a garage installation.

Failure to do so can result in death, explosion, or fire.

You will need

■A location that allows for proper exhaust installation. A gas dryer must be exhausted to the outdoors. See “Venting Requirements.”

■If you are using a power supply cord, a grounded electrical outlet located within 2 ft (61 cm) of either side of the dryer. See “Electrical Requirements.”

■A sturdy floor to support the total dryer weight of 200 lbs (90.7 kg). The combined weight of a companion appliance should also be considered.

■A level floor with a maximum slope of 1" (2.5 cm) under entire dryer. If slope is greater than 1" (2.5 cm), install Extended Dryer Feet Kit, Part Number 279810. Clothes may not tumble properly, and automatic sensor cycles may not operate correctly if dryer is not level.

■For a garage installation, you will need to place the dryer at least 18" (46 cm) above the floor. If using a pedestal, you will need to place the pedestal at least 6" (22.9 cm) above the floor.

Do not operate your dryer at temperatures below 45ºF (7ºC). At lower temperatures, the dryer might not shut off at the end of an automatic cycle. This can result in longer drying times.

The dryer must not be installed or stored in an area where it will be exposed to water and/or weather.

Check code requirements. Some codes limit, or do not permit, installation of the dryer in garages, closets, mobile homes or sleeping quarters. Contact your local building inspector.

NOTE: No other fuel-burning appliance can be installed in the same closet as a dryer.

Installation clearances

■The location must be large enough to allow the dryer door to open fully.

■Additional spacing should be considered for ease of installation and servicing.

■Additional clearances might be required for wall, door and floor moldings.

■Additional spacing of 1" (2.5 cm) on all sides of the dryer is recommended to reduce noise transfer.

■Companion appliance spacing should also be considered.

Dryer Dimensions

51½" (130.81 cm)

38"

(96.52 cm)

*31½"

(80 cm)27"

(68.6 cm)

*Most installations require a minimum 5½" (14 cm) clearance behind the dryer for the exhaust vent with elbow. See “Venting Requirements.”

FRONT-LOADING GAS DRYER specifications

The Whirlpool front-loading gas dryer is a pinnacle of modern laundry technology, combining efficiency, performance, and convenience. Designed to meet the demands of busy households, it offers a range of features that simplify the drying process while ensuring optimal results for all types of fabrics.

One of the standout features of this gas dryer is its advanced moisture sensing technology. The sensor detects when clothes are dry and automatically stops the cycle, preventing over-drying and saving energy. This not only protects garments from damage but also reduces energy consumption, making it an environmentally friendly choice.

In terms of capacity, the Whirlpool front-loading gas dryer boasts a generous drum size that accommodates large loads, allowing users to spend less time doing laundry. The smooth surface of the drum prevents snagging, which is especially important for delicate items. The dryer also features multiple drying cycles, including options for heavy-duty and delicate fabrics, ensuring tailored care for each load.

Moreover, the dryer is equipped with the EcoBoost option, which utilizes a lower heat setting and extended drying time to save energy without compromising drying quality. This makes it an ideal choice for the eco-conscious consumer seeking to reduce their carbon footprint.

Another remarkable characteristic of this gas dryer is its steam-enhanced cycles. The steam feature helps to reduce wrinkles and odors, providing a fresh finish to garments straight from the dryer. This is particularly beneficial for busy individuals who need to look sharp without the hassle of ironing.

The control panel of the Whirlpool front-loading gas dryer is designed for user-friendliness, featuring a clear display and intuitive controls that allow for easy selection of drying settings. The Wrinkle Shield option is also included, which periodically tumbles the load after the cycle ends to keep wrinkles at bay.

Safety is a key consideration in the design, and this dryer includes a lint screen that is easy to clean, ensuring that the appliance operates efficiently and safely.

In conclusion, the Whirlpool front-loading gas dryer is an excellent addition to any laundry room, providing a blend of advanced technologies, thoughtful features, and superior drying performance. Whether tackling everyday laundry or special care items, this dryer delivers on the promise of quality, efficiency, and convenience.