Miele G 7783 CD Correcting minor faults, Faults/Possible Causes, Machine does not start

Page 38

Correcting minor faults

With the aid of the following explana- tory notes, minor faults can usually be corrected without contacting the Miele Service Department.

Any work on the electrical components of the machine should only be carried out by a suitably qualified and compe- tent person.

Faults/Possible Causes

The machine does not start

Check that the door is properly shut.

Check the plug connection or isolator.

Check the fuses.

A few minutes after switching on, the indicator light p q flashes.

The stopcocks are closed.

The water inlet hose filters are dirty.

Switch off the machine.

Open the stopcocks or clean the fil- ters (see "Cleaning and care"). Switch on the machine again and re- select the programme.

The wash cycle finishes too early and the pq indicator light flashes

The drain hose is kinked.

The door was opened and closed during the programme.

There was an interruption to the power supply.

Correct the fault

Pump away the water and start the programme again (see procedure under "Interrupting a programme").

The water in the wash cabinet is not heated; the programme sequence lasts too long.

This machine has a resettable heater limiter which will switch off the heaters in the case of over-heating. This could be caused for example, if large articles obscure the heating elements or if the filters in the wash cabinet are blocked.

Remove cause of fault.

Take off service panel (see under "Electrical connection").

Press in the re-set button (blue) on the heater limiter.

If this switch trips repeatedly, your Ser- vice Dealer or the Miele Service Depart- ment must be contacted.

In the event of any faults which cannot be remedied, please contact your Ser- vice Dealer or the Miele Service Depart- ment.

34

Image 38
Contents CD Mielabor Contents Guide to the machine 10 11 12 13 Correct usage Page Page Accessories Disposal of an old machineDescription of the machine Available at extra costSetting the water softener Setting the WaterSoftenerReactivating the water softener, see To close the door Opening and closing the doorTo open the door a Removing excess soils Applications and loadingLoading the machine Loading example 106 Top basket frame can take various inserts109 Adjusting the top basket To adjust the top basketAdding Rinsing agent Setting the dosageRinsing agent Refilling with rinsing agentAdding detergents Adding neutralising agent and liquid detergentAdding neutralising agent Checking the dispensing system Venting the liquid dispensing system / MaintenanceVenting the liquid dispensing system Adding powder detergent Programme selection Programme B, and when using O-175 or a pipette plateAdding detergent Programme chart = Cold7783 CD Instructions for the operatorPage Page Accessories 93C 70C Selecting an additional pro- gramme Switching the machine on and offSelecting a programme Programme ChangesSwitching the machine on and off Interrupting a programme Programme sequence indicatorSwitching off 1c. AD water connection 1a. Cold water connection1b. Hot water connection Programming special functions Reactivating the water softener Filling the salt containerSwitch on the machine Position the salt container as followsCleaning the coarse filter Cleaning and careCleaning the filters in the water cabinet Cleaning the fine, flat and micro-fine filtersCleaning the filters in the water inlet Exchanging the S-class particle filter Drying unit TA cleaning and careChanging the Coarse Filter Machine does not start Correcting minor faultsFaults/Possible Causes Position and secure the machine InstallationImportant for machines with DHK steam condensor Cover plate worktop protection To remove service panel and cover plate Electrical connectionElectrical connection Plumbing Connection to the water inletAD connection to purified water, pressurised, 1.5 10 bar Connection to purified water non- pressurised 0 1.5 barDrainage Ventilation of the wash cabinet at rearDisposal of your old machine Caring for the environmentDisposal of the packing material Technical Data Noise emission in dB a