Miele G 7783 CD Drying unit TA cleaning and care, Changing the Coarse Filter

Page 37

Drying unit (TA) cleaning and care

Changing the Coarse Filter

The coarse filter should be changed when it is soiled or after approx. 100 operating hours, (see time counter on the TA unit).

Grip the inlet grille to the right and the left and pull up out of the re- tainers and then downwards and off.

Take out the perforated plate.

Change the coarse filter.

-The smooth side of the filter must face the rear.

Position the perforated plate at the base and press into place at the top. - The edge surround should face for- ward.

When putting back the inlet grille, it should audibly click into place.

Exchanging the S-class particle filter

If is advisable for this filter to be re- placed after approx. 500 operating hours (see the time counter on the TA control unit).

This filter should only be changed by an authorised Service Dealer or the MIELE Service department.

The effective operating of the machine can only be achieved if original "Miele" S - class particle filters are used.

33

Image 37

Contents CD Mielabor Contents Guide to the machine 10 11 12 13 Correct usage Page Page Disposal of an old machine AccessoriesAvailable at extra cost Description of the machineSetting the WaterSoftener Setting the water softenerReactivating the water softener, see To open the door a Opening and closing the doorTo close the door Loading the machine Applications and loadingRemoving excess soils Loading example 109 Top basket frame can take various inserts106 To adjust the top basket Adjusting the top basketRinsing agent Setting the dosageAdding Rinsing agent Refilling with rinsing agentAdding neutralising agent Adding neutralising agent and liquid detergentAdding detergents Venting the liquid dispensing system Venting the liquid dispensing system / MaintenanceChecking the dispensing system Adding powder detergent Adding detergent Programme B, and when using O-175 or a pipette plateProgramme selection = Cold Programme chartInstructions for the operator 7783 CDPage Page Accessories 93C 70C Selecting a programme Switching the machine on and offSelecting an additional pro- gramme Programme ChangesSwitching the machine on and off Switching off Programme sequence indicatorInterrupting a programme 1b. Hot water connection 1a. Cold water connection1c. AD water connection Programming special functions Filling the salt container Reactivating the water softenerPosition the salt container as follows Switch on the machineCleaning the filters in the water cabinet Cleaning and careCleaning the coarse filter Cleaning the fine, flat and micro-fine filtersCleaning the filters in the water inlet Changing the Coarse Filter Drying unit TA cleaning and careExchanging the S-class particle filter Faults/Possible Causes Correcting minor faultsMachine does not start Important for machines with DHK steam condensor InstallationPosition and secure the machine Cover plate worktop protection Electrical connection To remove service panel and cover plateElectrical connection Connection to the water inlet PlumbingConnection to purified water non- pressurised 0 1.5 bar AD connection to purified water, pressurised, 1.5 10 barVentilation of the wash cabinet at rear DrainageDisposal of the packing material Caring for the environmentDisposal of your old machine Noise emission in dB a Technical Data