Miele G 7783 CD operating instructions Accessories

Page 26

Warning and safety instructions

Accessories

Use special inserts in accordance with the instructions provided.

The only accessories to be used with the special commercial ma- chine must be those supplied or ap-

proved by MIELE for the specific appli- cation. Consult your dealer or the Miele Professional department for advice.

Disposal of an old machine

When disposing of an old machine first make it unusable. Disconnect, cut off the cable and any plug from the

cable. For environmental and safety reasons ensure the machine is com- pletely drained of any residue water and cleaning agent. (Observe safety regulations and wear safety goggles and gloves). Make the door lock inoper- ative, so that children cannot acciden- tally shut themselves in. The simplest way to do this is to remove the locking pin (2 philips screws above the door). Make appropriate arrangements for the safe disposal of the machine. For tank system machines ensure that any water is emptied out of the tank.

In countries where there are areas which may be subject to infesta-

tion by cockroaches or other vermin, pay particular attention to keeping the machine and its surroundings in a clean condition at all times. Any dam- age which may be caused by cock- roaches or other vermin will not be covered by the machine guarantee.

The manufacturer cannot be held re- sponsible for any damage caused through non-observance of these Warning and Safety instructions.

4

Image 26
Contents CD Mielabor Contents Guide to the machine 10 11 12 13 Correct usage Page Page Accessories Disposal of an old machineDescription of the machine Available at extra costSetting the water softener Setting the WaterSoftenerReactivating the water softener, see To close the door Opening and closing the doorTo open the door a Removing excess soils Applications and loadingLoading the machine Loading example 106 Top basket frame can take various inserts109 Adjusting the top basket To adjust the top basketAdding Rinsing agent Setting the dosageRinsing agent Refilling with rinsing agentAdding detergents Adding neutralising agent and liquid detergentAdding neutralising agent Checking the dispensing system Venting the liquid dispensing system / MaintenanceVenting the liquid dispensing system Adding powder detergent Programme selection Programme B, and when using O-175 or a pipette plateAdding detergent Programme chart = Cold7783 CD Instructions for the operatorPage Page Accessories 93C 70C Selecting an additional pro- gramme Switching the machine on and offSelecting a programme Programme ChangesSwitching the machine on and off Interrupting a programme Programme sequence indicatorSwitching off 1c. AD water connection 1a. Cold water connection1b. Hot water connection Programming special functions Reactivating the water softener Filling the salt containerSwitch on the machine Position the salt container as followsCleaning the coarse filter Cleaning and careCleaning the filters in the water cabinet Cleaning the fine, flat and micro-fine filtersCleaning the filters in the water inlet Exchanging the S-class particle filter Drying unit TA cleaning and careChanging the Coarse Filter Machine does not start Correcting minor faultsFaults/Possible Causes Position and secure the machine InstallationImportant for machines with DHK steam condensor Cover plate worktop protection To remove service panel and cover plate Electrical connectionElectrical connection Plumbing Connection to the water inletAD connection to purified water, pressurised, 1.5 10 bar Connection to purified water non- pressurised 0 1.5 barDrainage Ventilation of the wash cabinet at rearDisposal of your old machine Caring for the environmentDisposal of the packing material Technical Data Noise emission in dB a