Miele G 7783 CD operating instructions Cover plate worktop protection

Page 40

Installation

Depending on the various requirements for building under, the following kit may also be required:

Cover plate (worktop protection)

The underside of the work surface is protected from steam damage by a plate of stainless steel.

Open the door. Through each of the two holes in the front rim, left and right, screw the machine to the front edge of the continuous worktop.

Do not use silicone sealant to seal the gaps between the machine and any neighbouring units as this would hinder ventilation to the circulation pump.

36

Image 40

Contents CD Mielabor Contents Guide to the machine 10 11 12 13 Correct usage Page Page Accessories Disposal of an old machineDescription of the machine Available at extra costSetting the water softener Setting the WaterSoftenerReactivating the water softener, see To open the door a Opening and closing the doorTo close the door Loading the machine Applications and loadingRemoving excess soils Loading example 109 Top basket frame can take various inserts106 Adjusting the top basket To adjust the top basketSetting the dosage Rinsing agentAdding Rinsing agent Refilling with rinsing agentAdding neutralising agent Adding neutralising agent and liquid detergentAdding detergents Venting the liquid dispensing system Venting the liquid dispensing system / MaintenanceChecking the dispensing system Adding powder detergent Adding detergent Programme B, and when using O-175 or a pipette plateProgramme selection Programme chart = Cold7783 CD Instructions for the operatorPage Page Accessories 93C 70C Switching the machine on and off Selecting a programmeSelecting an additional pro- gramme Programme ChangesSwitching the machine on and off Switching off Programme sequence indicatorInterrupting a programme 1b. Hot water connection 1a. Cold water connection1c. AD water connection Programming special functions Reactivating the water softener Filling the salt containerSwitch on the machine Position the salt container as followsCleaning and care Cleaning the filters in the water cabinetCleaning the coarse filter Cleaning the fine, flat and micro-fine filtersCleaning the filters in the water inlet Changing the Coarse Filter Drying unit TA cleaning and careExchanging the S-class particle filter Faults/Possible Causes Correcting minor faultsMachine does not start Important for machines with DHK steam condensor InstallationPosition and secure the machine Cover plate worktop protection To remove service panel and cover plate Electrical connectionElectrical connection Plumbing Connection to the water inletAD connection to purified water, pressurised, 1.5 10 bar Connection to purified water non- pressurised 0 1.5 barDrainage Ventilation of the wash cabinet at rearDisposal of the packing material Caring for the environmentDisposal of your old machine Technical Data Noise emission in dB a