Miele T 7644 C operating instructions Cleaning and care, Emptying the condensed water container

Page 23

Cleaning and care

Emptying the condensed water container

Water separated from laundry by drying is collected in the condensed water container.

Empty the container after every drying program.

The Container indicator light comes on when the maximum water level in the container has been reached.

It will go out when the door has been opened and closed again.

￿Close the door completely. Otherwise, the door and the handgrip panel could be damaged when the container is pulled out.

￿Pull out the condensed water container.

￿Carry the container levelly so that water does not pour out. Hold it by the handgrip panel and the end.

￿Empty the condensed water container.

￿Return it to the dryer.

￿Do not drink condensed water! It could cause health problems for humans or pets.

You may use condensed water for household uses (for steam ironing, or for air humidifiers for instance). First pass the condensed water through a fine sieve or a coffee filter. The finest lint, which might otherwise cause damage, will be filtered from the water.

23

Image 23
Contents Operating Instructions For condenser tumble dryer T 7644 C Saving energy Caring for the environmentDisposal of packing material Disposing of your old applianceContents Contents Important Safety Instructions Grounding Instructions This dryer is intended for residential use onlyAccessories Function of Miele condenser dryer Main FeaturesDescription Operating the dryer Dear CustomerLaundry care anti-crease action and roll-up prevention To do all this, the dryer is equipped with systemsDisplay Fault indicator / Optical interfaceOperating the dryer Control panelProgrammable functions DelayProgram duration/ Estimated time remaining Drying Care symbolsLaundry care Drying tipsLaundry care Turn on the dryer Proper dryingBrief instructions Preparing the laundryDryness level selection in programs Extra options/Select DelaySelect program End of program Remove laundry Starting the programBefore the end of a program Buzzer Options/DelayDelay GentleWrinkle-free Extra dry, Normal, Hand iron Program OverviewNormal Extra dry, Normal Hand iron, Rotary ironDress shirts Normal, Hand iron WoolensSmoothing Express Normal, Hand ironTimed warm Timed coldTime remaining Switching over from a running programChanging the program sequence Loading or removing laundryDeactivating the lock Electronic lockActivating the lock Emptying the condensed water container Cleaning and careCleaning without water Cleaning the lint filtration componentsCleaning with water Cleaning the dryerRemoving the condenser unit Cleaning the condenser heat exchanger unitChecking the condenser unit Handle of the unit must be on top, the locking lever down Replacing the condenser unitWhat to do, if . . . ? Trouble shootingTest and fault messages Container indicator light Problem Cause SolutionCanceling test Canceling the faultOther problems Condenser has been Problem Cause Solution Water runs fromCleaned Dryer afterLights for these programs Start and the indicatorWhen switched on Cold programs will notReplacing the light bulb Optional accessories Customer serviceProgram updates Warranty conditions and warranty periodFront view Installation and connectionWasher-dryer stack Rear view Installation siteCarrying the dryer to the installation site Leveling the dryer Before transport at a later date Ventilating the installation areaArranging the drain hose Draining condensed water externallyGeneral Hooking up the drain hose in sink or floor drain Special installation conditions requiring a non-return valveInstallation and connection Electrical connections Technical data Programmable functions for changing Standard values Extending the range of drying levels Programmable functionsFor programming and saving in memory, follow steps to Adjusting buzzer volumeBuzzer normal default setting Buzzer loud Memory No Memory default settingSet memory function Extending cooldown time Change function of Filter/Vent indication Default settingNo Keypad tone default setting Keypad tone on Adjust keypad toneImportant condition Changing water conductivity settingDefault setting Lower conductivity setting Page Page Page Alteration rights reserved Nr 323 260