Miele T 7644 C operating instructions Replacing the light bulb

Page 34

Trouble shooting

Replacing the light bulb

Disconnect the dryer from the electrical supply.

Open the door.

The bulb should be of the same type and maximum wattage indicated on the data plate and the lighting cover.

Replace the bulb.

The hinged cover for the lighting is over the port-hole.

Gently insert an ordinary tool* under the side of the cover.

* such as a wide slot-type screwdriver

Open the cover by pressing lightly while rotating your wrist.

The cover opens downwards.

The heat-resistant bulb should be obtained only from Miele customer ser- vice.

Fold the cover upwards and press it on the right and left until you hear it latch.

Ensure that the cover is properly seated. If moisture gets inside it may cause a short-circuit.

34

Image 34

Contents Operating Instructions For condenser tumble dryer T 7644 C Disposing of your old appliance Caring for the environmentDisposal of packing material Saving energyContents Contents Important Safety Instructions This dryer is intended for residential use only Grounding InstructionsAccessories Operating the dryer Dear Customer Main FeaturesDescription Function of Miele condenser dryerTo do all this, the dryer is equipped with systems Laundry care anti-crease action and roll-up preventionControl panel Fault indicator / Optical interfaceOperating the dryer DisplayProgram duration/ Estimated time remaining DelayProgrammable functions Drying tips Care symbolsLaundry care DryingLaundry care Preparing the laundry Proper dryingBrief instructions Turn on the dryerSelect program Extra options/Select DelayDryness level selection in programs Before the end of a program Starting the programEnd of program Remove laundry Gentle Options/DelayDelay BuzzerHand iron, Rotary iron Program OverviewNormal Extra dry, Normal Wrinkle-free Extra dry, Normal, Hand ironExpress Normal, Hand iron WoolensSmoothing Dress shirts Normal, Hand ironTimed cold Timed warmLoading or removing laundry Switching over from a running programChanging the program sequence Time remainingActivating the lock Electronic lockDeactivating the lock Cleaning and care Emptying the condensed water containerCleaning the lint filtration components Cleaning without waterCleaning the dryer Cleaning with waterCleaning the condenser heat exchanger unit Removing the condenser unitChecking the condenser unit Replacing the condenser unit Handle of the unit must be on top, the locking lever downTest and fault messages Trouble shootingWhat to do, if . . . ? Canceling the fault Problem Cause SolutionCanceling test Container indicator lightOther problems Dryer after Problem Cause Solution Water runs fromCleaned Condenser has beenCold programs will not Start and the indicatorWhen switched on Lights for these programsReplacing the light bulb Warranty conditions and warranty period Customer serviceProgram updates Optional accessoriesInstallation and connection Front viewCarrying the dryer to the installation site Rear view Installation siteWasher-dryer stack Leveling the dryer Ventilating the installation area Before transport at a later dateGeneral Draining condensed water externallyArranging the drain hose Special installation conditions requiring a non-return valve Hooking up the drain hose in sink or floor drainInstallation and connection Electrical connections Technical data Programmable functions for changing Standard values Programmable functions Extending the range of drying levelsBuzzer normal default setting Buzzer loud Adjusting buzzer volumeFor programming and saving in memory, follow steps to Set memory function No Memory default settingMemory Extending cooldown time Default setting Change function of Filter/Vent indicationAdjust keypad tone No Keypad tone default setting Keypad tone onDefault setting Lower conductivity setting Changing water conductivity settingImportant condition Page Page Page Alteration rights reserved Nr 323 260