Miele T 7644 C operating instructions Checking the condenser unit

Page 27

Cleaning and care

￿Pull the condenser by its handle out of its housing.

Checking the condenser unit

￿Hold the condenser up to the light in two directions:

￿Look to see whether there is lint inside it.

The arrows in the illustration above indicate where to look.

If no lint is visible:

￿Replace the condenser unit (see the next page).

If lint is visible:

￿Clean the condenser unit as described below.

Cleaning the condenser unit

￿When rinsing the condenser unit, be sure to position it as shown in the following two illustrations:

￿Rinse the unit from the longitudinal side with a stream of water – as shown in the top illustration.

27

Image 27
Contents Operating Instructions For condenser tumble dryer T 7644 C Saving energy Caring for the environmentDisposal of packing material Disposing of your old applianceContents Contents Important Safety Instructions Grounding Instructions This dryer is intended for residential use onlyAccessories Function of Miele condenser dryer Main FeaturesDescription Operating the dryer Dear CustomerLaundry care anti-crease action and roll-up prevention To do all this, the dryer is equipped with systemsDisplay Fault indicator / Optical interfaceOperating the dryer Control panelDelay Program duration/ Estimated time remainingProgrammable functions Drying Care symbolsLaundry care Drying tipsLaundry care Turn on the dryer Proper dryingBrief instructions Preparing the laundryExtra options/Select Delay Select programDryness level selection in programs Starting the program Before the end of a programEnd of program Remove laundry Buzzer Options/DelayDelay GentleWrinkle-free Extra dry, Normal, Hand iron Program OverviewNormal Extra dry, Normal Hand iron, Rotary ironDress shirts Normal, Hand iron WoolensSmoothing Express Normal, Hand ironTimed warm Timed coldTime remaining Switching over from a running programChanging the program sequence Loading or removing laundryElectronic lock Activating the lockDeactivating the lock Emptying the condensed water container Cleaning and care Cleaning without water Cleaning the lint filtration componentsCleaning with water Cleaning the dryerRemoving the condenser unit Cleaning the condenser heat exchanger unitChecking the condenser unit Handle of the unit must be on top, the locking lever down Replacing the condenser unitTrouble shooting Test and fault messagesWhat to do, if . . . ? Container indicator light Problem Cause SolutionCanceling test Canceling the faultOther problems Condenser has been Problem Cause Solution Water runs fromCleaned Dryer afterLights for these programs Start and the indicatorWhen switched on Cold programs will notReplacing the light bulb Optional accessories Customer serviceProgram updates Warranty conditions and warranty periodFront view Installation and connectionRear view Installation site Carrying the dryer to the installation siteWasher-dryer stack Leveling the dryer Before transport at a later date Ventilating the installation areaDraining condensed water externally GeneralArranging the drain hose Hooking up the drain hose in sink or floor drain Special installation conditions requiring a non-return valveInstallation and connection Electrical connections Technical data Programmable functions for changing Standard values Extending the range of drying levels Programmable functionsAdjusting buzzer volume Buzzer normal default setting Buzzer loudFor programming and saving in memory, follow steps to No Memory default setting Set memory functionMemory Extending cooldown time Change function of Filter/Vent indication Default settingNo Keypad tone default setting Keypad tone on Adjust keypad toneChanging water conductivity setting Default setting Lower conductivity settingImportant condition Page Page Page Alteration rights reserved Nr 323 260