Miele T 7644 C operating instructions Installation and connection

Page 42

Installation and connection

1 Adapter

2Sink coupling nut

3 Hose clip

4 End of hose

5 Non-return valve

6 Dryer drain hose

Fit the adapter to the sink drain outlet 1 with the sink coupling nut 2.

Usually the sink coupling nut has a flat washer, which you must remove.

Fit the end of the hose 4 to the adapter 1.

Using a screwdriver, tighten the hose clip 3 directly behind the sink coupling nut.

Install the non-return valve 5 so that the arrow points in the direction of flow (towards the sink). Otherwise, pumping out will be impossible.

Insert the non-return valve 5 into the dryer drain hose 6 (make sure it is connected in the right direction, check the arrow on the non-return valve!).

Attach the non-return valve using the hose clips.

42

Image 42

Contents Operating Instructions For condenser tumble dryer T 7644 C Disposing of your old appliance Caring for the environmentDisposal of packing material Saving energyContents Contents Important Safety Instructions This dryer is intended for residential use only Grounding InstructionsAccessories Operating the dryer Dear Customer Main FeaturesDescription Function of Miele condenser dryerTo do all this, the dryer is equipped with systems Laundry care anti-crease action and roll-up preventionControl panel Fault indicator / Optical interfaceOperating the dryer DisplayDelay Program duration/ Estimated time remainingProgrammable functions Drying tips Care symbolsLaundry care DryingLaundry care Preparing the laundry Proper dryingBrief instructions Turn on the dryerExtra options/Select Delay Select programDryness level selection in programs Starting the program Before the end of a programEnd of program Remove laundry Gentle Options/DelayDelay BuzzerHand iron, Rotary iron Program OverviewNormal Extra dry, Normal Wrinkle-free Extra dry, Normal, Hand ironExpress Normal, Hand iron WoolensSmoothing Dress shirts Normal, Hand ironTimed cold Timed warmLoading or removing laundry Switching over from a running programChanging the program sequence Time remainingElectronic lock Activating the lockDeactivating the lock Cleaning and care Emptying the condensed water containerCleaning the lint filtration components Cleaning without waterCleaning the dryer Cleaning with waterCleaning the condenser heat exchanger unit Removing the condenser unitChecking the condenser unit Replacing the condenser unit Handle of the unit must be on top, the locking lever downTrouble shooting Test and fault messagesWhat to do, if . . . ? Canceling the fault Problem Cause SolutionCanceling test Container indicator lightOther problems Dryer after Problem Cause Solution Water runs fromCleaned Condenser has beenCold programs will not Start and the indicatorWhen switched on Lights for these programsReplacing the light bulb Warranty conditions and warranty period Customer serviceProgram updates Optional accessoriesInstallation and connection Front viewRear view Installation site Carrying the dryer to the installation siteWasher-dryer stack Leveling the dryer Ventilating the installation area Before transport at a later dateDraining condensed water externally GeneralArranging the drain hose Special installation conditions requiring a non-return valve Hooking up the drain hose in sink or floor drainInstallation and connection Electrical connections Technical data Programmable functions for changing Standard values Programmable functions Extending the range of drying levelsAdjusting buzzer volume Buzzer normal default setting Buzzer loudFor programming and saving in memory, follow steps to No Memory default setting Set memory functionMemory Extending cooldown time Default setting Change function of Filter/Vent indicationAdjust keypad tone No Keypad tone default setting Keypad tone onChanging water conductivity setting Default setting Lower conductivity settingImportant condition Page Page Page Alteration rights reserved Nr 323 260