Miele T 7644 C Adjusting buzzer volume, For programming and saving in memory, follow steps to

Page 47

Programmable functions

Adjusting buzzer volume

The buzzer has two volumes.

For programming and saving in memory, follow steps to .

This function is programmed using the buttons.

Precondition:

–The dryer is switched off.

–The door is closed.

Press Start/Stop and keep it pressed it during steps -.

Press the I-On/0-Offbutton in.

Wait until the Start/Stop button lights up continuously . . .

. . . then release the Start/Stop button.

Press the Gentle button once.

–The Gentle indicator light flashes briefly four times.

–P and 0 flash alternatingly in the display (default setting).

The number appearing alternatingly with P means:

0Buzzer normal (default setting)

IBuzzer loud

(Express indicator light also flashes)

Pressing the Start/Stop button switches from one number to the other, and you simultaneously hear the buzzer setting.

Using the I-On/0-Offbutton, switch the dryer off.

The programming is now stored in memory. You can change it again at any time.

47

Image 47

Contents Operating Instructions For condenser tumble dryer T 7644 C Saving energy Caring for the environmentDisposal of packing material Disposing of your old applianceContents Contents Important Safety Instructions Grounding Instructions This dryer is intended for residential use onlyAccessories Function of Miele condenser dryer Main FeaturesDescription Operating the dryer Dear CustomerLaundry care anti-crease action and roll-up prevention To do all this, the dryer is equipped with systemsDisplay Fault indicator / Optical interfaceOperating the dryer Control panelProgrammable functions DelayProgram duration/ Estimated time remaining Drying Care symbolsLaundry care Drying tipsLaundry care Turn on the dryer Proper dryingBrief instructions Preparing the laundryDryness level selection in programs Extra options/Select DelaySelect program End of program Remove laundry Starting the programBefore the end of a program Buzzer Options/DelayDelay GentleWrinkle-free Extra dry, Normal, Hand iron Program OverviewNormal Extra dry, Normal Hand iron, Rotary ironDress shirts Normal, Hand iron WoolensSmoothing Express Normal, Hand ironTimed warm Timed coldTime remaining Switching over from a running programChanging the program sequence Loading or removing laundryDeactivating the lock Electronic lockActivating the lock Emptying the condensed water container Cleaning and careCleaning without water Cleaning the lint filtration componentsCleaning with water Cleaning the dryerRemoving the condenser unit Cleaning the condenser heat exchanger unitChecking the condenser unit Handle of the unit must be on top, the locking lever down Replacing the condenser unitWhat to do, if . . . ? Trouble shootingTest and fault messages Container indicator light Problem Cause SolutionCanceling test Canceling the faultOther problems Condenser has been Problem Cause Solution Water runs fromCleaned Dryer afterLights for these programs Start and the indicatorWhen switched on Cold programs will notReplacing the light bulb Optional accessories Customer serviceProgram updates Warranty conditions and warranty periodFront view Installation and connectionWasher-dryer stack Rear view Installation siteCarrying the dryer to the installation site Leveling the dryer Before transport at a later date Ventilating the installation areaArranging the drain hose Draining condensed water externallyGeneral Hooking up the drain hose in sink or floor drain Special installation conditions requiring a non-return valveInstallation and connection Electrical connections Technical data Programmable functions for changing Standard values Extending the range of drying levels Programmable functionsFor programming and saving in memory, follow steps to Adjusting buzzer volumeBuzzer normal default setting Buzzer loud Memory No Memory default settingSet memory function Extending cooldown time Change function of Filter/Vent indication Default settingNo Keypad tone default setting Keypad tone on Adjust keypad toneImportant condition Changing water conductivity settingDefault setting Lower conductivity setting Page Page Page Alteration rights reserved Nr 323 260