Miele T 7644 C operating instructions Replacing the condenser unit

Cleaning and care

￿Rinse the unit from the front with a stream of water.

￿Check the condenser unit once more for visible fouling (see "Checking the Condenser Unit"). Rinse as often as necessary.

￿Ensure that the condenser unit rubber seals are clean.

Seals should not be removed and must be free of kinks.

Checking and cleaning the condenser unit housing

￿Check the condenser unit housing inside the dryer for visible lint.

Using a damp cloth, wipe it only from areas you can reach with your hand.

Replacing the condenser unit

￿Push the condenser unit fully (to the stop) back into its housing.

The handle of the unit must be on top, the locking lever down.

￿Rotate the locking lever into the horizontal position so that its hooks clearly latch down into the groove in the base of the housing.

When replacing the inner cover, ensure that the rubber seal is correctly seated in its groove.

￿Locate the inner cover so that its latching hooks are down. While doing so, hold it at an angle and push it gently downwards.

￿Push against the cover and latch it with its locking lever.

After latching, the locking lever must be horizontal.

￿Insert the bottom of the external panel and press until the upper edge latches into position.

￿Only a correctly inserted and latched condenser unit will ensure the watertightness of the system!

28