GE GFWN1000, WBVH5300 installation instructions Cleaning the Pump Filter, Cleaning the Door Gasket

Pour spout

Pour spout

GEAppliances.com

Cleaning the Pump Filter

Due to the nature of the front-load washer, it is sometimes possible for small articles to pass to the pump. The washer has a filter to capture lost items so they are not dumped to the drain. To retrieve lost items, clean out the pump filter.

1. Using a coin or flat screwdriver	Pump
in the notch on the door, open	filter
the access door.

2. Place a shallow pan or dish under the pump access door and towels on the floor in front of the washer to protect the floor. It is normal to catch about a cup of water when the filter is removed.

3.Pull down the pour spout.

4.Turn the pump filter counterclockwise and remove the filter. Open slowly to allow the water to drain.

5.Clean the debris from the filter.

6.Replace the filter and turn clockwise. Tighten securely.

7.Flip up the pour spout.

8.Close the access door.

Safety Instructions Operating Instructions

Installation Instructions

Troubleshooting Tips

Cleaning the Door Gasket

Open the washer door. Using both hands, press down the door gasket. Remove any foreign objects if found trapped inside the gasket. Make sure there is nothing blocking the holes behind the gasket.

While holding down the door gasket, inspect the interior gasket by pulling it down with your fingers. Remove any foreign objects if found trapped inside this gasket. Make sure there is nothing blocking the holes behind the gasket.

When you are finished cleaning the door gasket, remove your hands and the gasket will return to the operating position.

13

Consumer Support