GE WBVH5300, GFWN1000 About the washer features, Cycle Signal, Extra Rinse, Lock

Operating Instructions Safety Instructions

Installation Instructions

Support Troubleshooting Tips

About the washer features.

noTE: Features may not be available on all washer models.

7			Cycle Signal
			Use the SIGNAL button to change	Press the button until you reach
			the volume of the end of cycle signal.	the desired volume.
8			Prewash (on some models)	detergent, or the proper wash additive
			Prewash is an extra wash before
			the main wash. Use it for heavily soiled	to the prewash dispenser.
			clothes or for clothes with a care label	NOTE: When selecting prewash,
			that recommends prewashing before
				it is recommended to use powder
			washing. Be sure to add high-efficiency
				detergent in the main wash (detergent)
				compartment.
9			Extra Rinse
			Use an extra rinse when additional rinsing
			is desired to remove excess dirt and
			detergent from soiled loads.
10			Delay Start (on some models)
			You can delay the start of a wash cycle	NOTE: If you forget to fully close the door,
			for 10–18 hours, depending on the model.	a reminder signal will beep reminding you
			Press the DELAY START button to choose	to do so.
			the number of hours you want to delay	NOTE: If you open the door when the delay
			the start of the cycle, then press the START
				is counting down, the machine will enter
			button. The machine will count down and
				the pause state. You must close the door
			start automatically at the correct time.
				and press START again in order to restart
				the countdown.
11			Lock
			You can lock the controls to prevent any	To lock the washer, press and hold
			selections from being made. Or you can
				the DELAY START button for 3 seconds
			lock the controls after you have started
				(on some models use SIGNAL button).
			a cycle.
				To unlock the washer controls, press
			children cannot accidentally start	and hold the DELAY START button for
				3 seconds.
			the washer by touching pads with
			this option selected.	The control lock icon on the display will
				light up when it is on.
				NOTE: The POWER button can still be
				used when the machine is locked.
12			MY CYCLE (on some models)
			To save a favorite cycle, set the desired	NOTE: When using MY CYCLE, wash
	HOLD 3 SEC	MY CYCLE	settings for wash cycle, soil level, spin speed
				options cannot be modified after the
	TO STORE
			and wash temp settings and hold down the	cycle has been started.
			MY CYCLE button for 3 seconds. A beep will
				NOTE: If you change wash options with
			sound to indicate the cycle has been saved.
				MY CYCLE before starting the cycle, the

To use your custom cycle, press the	MY CYCLE light will turn off and you will
MY CYCLE button before washing a load.
	be returned to the base cycle.
To change the saved cycle, set the desired
settings and hold down the MY CYCLE
button for 3 seconds.

Consumer

13

8

BASKET CLEAN

BasketClean is a cycle that freshens up the inside of your washer. The cycle uses bleach or other available washing machine cleaners and more water to refresh your washer. Use BasketClean

once every month to reduce odor and residue buildup inside the washer.

For more information on BasketClean, refer to the care and cleaning section on page 12.