WASHER CARE
Cleaning the exterior
Use a soft, damp cloth or sponge to wipe up any spills such as detergent or bleach. Occasionally wipe the outside of your washer to keep it looking new.
Cleaning the interior
Add 1 cup (250 mL) of chlorine bleach and 1 scoop or capful of detergent to the washer, and run it through a normal cycle using hot water. Repeat this process if necessary,
NOTE: Remove any hard water deposits using only cleaners labeled as washer safe,
Cleaning the lint filter:
Clean filter after every load,
1.Grasp the top of the fabric softener dispenser and pull straight upward to remove. The lint filter is attached to the end of the shaft.
2.Wash or wipe the lint filter clean.
3.Push fabric softener dispenser and lint filter firmly back into agitator.
Cleaning the liquid fabric softener dispenser:
Flush fabric softener dispenser periodically with warm water.
1.Grasp the top of the dispenser and pull upward to remove.
2.Flush the dispenser with warm water. Replace after cleaning.
NOTE: To avoid damage to the washer or clothing, do not wash clothes with the fabric softener dispenser removed. Do not add detergent or bleach to this dispenser; it is for liquid fabric softener only.
Replace inlet hoses after five years of use to reduce the risk of hose failure. Periodically inspect and replace inlet hoses if bulges, kinks, cuts, wear or leaks are found.
When replacing your inlet hoses, mark the date of replacement on the label with a permanent marker.
Install and store your washer where it will not freeze. Because some water may stay in the hoses, freezing can damage your washer. If storing or moving your washer during freezing weather, winterize it.
Non-use or vacation care:
Operate your washer only when you are at home. If you will be on vacation or not using your washer for an extended period of time, you should:
•Unplug washer or disconnect power.
•Turn off the water supply to the washer. This helps avoid accidental flooding (due to a water pressure surge) while you are away.
To winterize washer:
1.Shut off both water faucets.
2.Disconnect and drain water inlet hoses.
3.Put 1 qt (1 L) of
4.Unplug washer or disconnect power.
To use washer again:
1.Flush water pipes and hoses,
2.Reconnect water inlet hoses.
3.Turn on both water faucets,
4.Plug in washer or reconnect power.
5.Run the washer through any cycle with 1/2the normal recommended amount of detergent to clean out the antifreeze.
To transport the washer:.
1.Shut off both water faucets.
2.Disconnect and drain water inlet hoses.
3.If washer will be moved during freezing weather, put in 1 qt (1 L) of
4.Disconnect the drain from the drain system.
5.Unplug the power cord,
6.Place the inlet hoses into the basket.
7.Drape the power cord and drain hose over edge into the basket,
Reinstalling the washer
1.Follow the installation instructions for your model to locate, level and connect the washer.
2.Run the washer through any cycle with 1/2the normal recommended amount of detergent to clean out the antifreeze, if used.
16