Maytag MAH-1 Water USE, Select the Signal, Start Your Maytag Neptune Washer, Indicator Lights

OPERATING INSTRUCTIONS CONT.

Step 6

SELECT THE SIGNAL

Press the “+” or “-” signal pad to increase or decrease the end of cycle signal volume.

Step 7

START YOUR MAYTAG NEPTUNE® WASHER

• Close the door.

• Add detergent and additives to the dispenser (See page 6).

•Push the start/pause pad.

•When the washer is started after a pause, there will be a 30-second delay before continuing the cycle.

Pressing off cancels the cycle and stops the washer,

NOTE: When the cycle is complete, the door locked light will go out.The door will open easily. DO NOT attempt to open the washer door when the door locked light is illuminated.To add a forgotten item, see pg. 2.

ESTIMATED TIME DISPLAY

After pressing start/pause, this display will show the estimated time remaining

in the cycle. The estimated time remaining may fluctuate to better indicate the

wash time left in the cycle.

INDICATOR LIGHTS

door locked – Lights whenever the door of the clothes washer is locked.The door can be unlocked by pressing the start/pause pad to stop the washer.

Pad Indicator Lights – The indicator lights above the pads will illuminate when the pad is selected.

WATER USE

The amount of water used will vary with each load.The Maytag Neptune® clothes washer uses an adaptive fill valve to provide the appropriate amount of water for efficient cleaning performance and conservation of water and energy. Fill time will vary depending on water pressure.

5