Kenmore 796.8051 Optional Accessories, Stacking KIT Installation, This stacking kit includes

Page 29

II

OPTIONAL ACCESSORIES

'-'3

(_ ..........................t=J

Usethe LP CONVERSIONKIT for changingthe dryer gas connectionsfrom NaturalGas

Usea pedestalto make

Use the stackingkit to mount

laundryeasier to reach.

the dryer on top of the washer

White = 796.51022

to savefloor space

Ginger = 796.51028

D26

17002

(White)

Chili Pepper= 796.51029

D26

17008

(Ginger)

 

D26

17009

(ChiliPepper)

_.

Usethe side vent kitfor

ventingdirectlyon either side or on the bottom. Kit # D26-49670

(NG) to LiquefiedPropaneGas (LP)

4948EL40020

NOTE: Installationof the LP conversion kit must be performedby a qualified service professional.

STACKING KIT INSTALLATION

This stacking kit includes:

•Two (2) side rails

•One (1) front rail

•Four (4) screws

Tools Needed for Installation: __

• Phillips-head screwdriver

0Make sure the top surface of the washer is clean and dry. Remove the paper backing from the foam

tape on one of the stacking kit side brackets.

\

J

OInstall each side rail on the side of the washer top as shown. Firmly press the foam tape in place at the front. Secure the rear of the bracket with a

screw from the back.

,,,

j

Dryer

Washer

,,WARNING"

•Incorrect installation can cause serious accidents.

The weight of the dryer and the height of installa- tion make this stacking procedure too risky for one person. Two or more people are required when installing the stacking kit. There is a risk of serious back injury or other injuries.

Do not use the stacking kit with a gas dryer in potentially unstable conditions such as a mobile home. Failure to follow this warning can result in seri- ous injury.

Place the washer on a solid, stable, level floor capable of supporting the weight of both appli ances. Failure to follow this warning can result in seri- ous injury.

Do NOT stack the washer on top of the dryer. Failure to follow this warning can result in serious injury.

If appliances are already installed, disconnect them from all power, water, or gas lines and from drain- ing or venting connections. Failure to do so can result in electrical shock, fire, explosion, or death.

i

OPlace the dryer on top of the washer with the feet slightly forward of the brackets in the side rails as shown. Slide the dryer back until the rear feet are held in place by the rear brackets of the stacking kit. CAUTION: Use care to avoid catching or pinch- ing fingers while positioning the dryer.

OInsert the cross rail between the washer and dryer with the tabs on top. Push the rail back until the tabs are on top of the feet and the screw holes line up. Install one screw on each end of the rail to lock it and the dryer in place.

29

II

Page 28 Page 30
Image 29
Page 28 Page 30
Contents Secadora Installation MaintenanceMaster Protection Agreements CongratUlations on making a smart purchase, Your newRead ALL Instructions Before USE Follow basic precautions, including the following Basic Safety PrecautionsGas dryers Must be exhausted to the outside Place dryer at least 18 in. above the floor for aDo not place candle and cigarettes on top For personal safety, this dryer must be properly Safety Instructions for Connecting ElectricityEASY-TO-USE Control Panel KEY Parts and ComponentsAdditional Instructions for Closet installations KEY Dimensions SpecificationsSection Special Electrical Requirements for Mobile or Manufactured Homes onRequired Dimensions for Installation With Stacking Kit Required Dimensions for Installation With PedestalInstallation with Optional Pedestal Base or Stacking KIT Electrical Requirements for Gas Models Only GAS Requirements GAS Models Connecting GAS DryersConnecting the Gas Supply Connecting GAS DryersHigh-Altitude Installations Proceed to Venting the Dryer onWAR Ning Toreducetheriskoffire Electrical Requirements Connecting Electric DryersThree-Wire Power Cord Connecting Electric DryersFour-Wire Power Cord Selecting and Verifying Duct Length Chart Venting the Dryer Check Your Exhaust System for ProblemsUsing the Duct Requirements Chart below Venting the Dryer Routing and Connecting DuctworkConnecting the Dryer Vent Reversing the Door Swing Leveling the DryerTesting Dryer Heating Final Installation CheckChecking Venting Checking LevelnessCycle Selector Knob Control Panel FeaturesOperating the Dryer Clean the Lint FilterRack Dry Cycle GuideModifiersOptions Sensor Dry Cycles Manual Dry CyclesLoading the Dryer Sorting LoadsCheck the Lint Filter Before Every Load Fabric Care LabelsLint Filter Indicator Estimated Time Remaining Check Vent IndicatorControl Lock Indicator Cycle Status IndicatorDry Level Cycle Modifier ButtonsWrinkle Guard Rack DRY Cycle Cycle Options and Special FeaturesCleaning the Exterior Regular CleaningCleaning the Lint Filter Cleaning Around and Under the DryerGreasy or dirty spots on clothes Before Calling for Service Check Vent Indicator is BlinkingDryer will not turn on Dryer does not heatDrying time is not consistent Before Calling for SERVICEcontClothes take too long to dry Check ThenClothes are shrinking Before Calling for ServiceClothes are wrinkled Stacking KIT Installation Optional AccessoriesTools Needed for Installation This stacking kit includesTools Needed Pedestal InstallationList of Parts Option 2 Bottom venting Side Venting KIT InstallationDisclaimer of implied warranties limitation of remedies One-Year Limited WarrantyPage Garantja LEA Todas LA Instrucciones Antes DE Usar Precauciones Basicas DE Seguridad Instrucciones Importante Para LA Instalacion Guarde Estas Instrucciones Panel DE Control F,,CIL DE Usar Piezas Y Componentes SignificativosEn armario Dimensiones Y Especificaciones SignificativasInstrucciones Adicionales Instalacion CON Base DE Pedestal O KIT DE Apilado Opcional Dimensiones precisas para la instalacion con pedestalRequerimientos electricos solo para modelos de gas Conexidn del suministro de gas Conexion DE LAS Secadoras DE GASCONEXlON DE LAS Secadoras DE Elictricas Requerimientos DE ElictricosCable de alimentacion trifilar CONEXlON DE LAS Secadoras DE ElictricasCable De alimentacion Tetrafilar 77!i!!ili!777777777777777777777777 Ventilacion DE LA SecadoraCuadro de seleccion y comprobacion de Iongitud del conducto Conexion del conducto de ventilacion de la secadora Ventilacion DE LA SecadoraTrayectoria y conexion de los conductos Cambio DE Sentido DEL Giro DE Apertura DE LA Puerta Nivelacion DE LA SecadoraPrueba de calentamiento de la secadora Comprobacion Final DE LA InstalacionComprobacion de la ventilacion Comprobacion de la nivelacionFunciones DEL Panel DE Control Boton Power enc./apagCargar LA Secadora Funcionamiento DE LA SecadoraSecado DesinDeja Carga DE LA Secadora Clasificacion DE CargasComprobar EL Filtro DE Pelusas Antes DE Cada Carga Etiquetas de prendas delicadasSistema DE DETECClON DE Bloqueo DEL La temperatura entre Botones Modificadores DE CicloTimed Wrinkle Guard anti-arrugas Opciones DEL Ciclo Y Funciones EspecialesControl Lock bloqueo de controles MY Cycle mi cicloLimpieza del filtro de pelusas Limpieza del exteriorLimpieza del interior Limpieza alrededor y bajo la secadoraLa secadora no calienta La secadora no se enciendeManchas de grasa o suciedad en las prendas Antes DE Solicitar Asistencia TicnicaAntes DE Solicitar Asistencia TleCNICA El tiempo de secado no es consistenteLas prendas tardan mucho en secarse Las prendas estan arrugadas La pantalla Muestra el codigo de error TEl 6 TE2Las prendas han encogido Pelusa sobre las prendasInstalacion DEL KIT DE Apilado Accesorios OpcionalesEste kit de apilado incluye Herramientas necesarias para la instalacionHerramientas necesarias Listado de piezasInstalacion DEL Pedestal Una instalacion incorrectapuedeprovocaraccidentesgravesOpci6n 2 ventilaci6n por la base Instalacion DEL KIT DE Ventilacion LateralGarantia limitada de un aho Page Page
Top Page Image Contents