Emerson 00825-0100-4716, 3095 manual Installing the HART Modem, Continued, Select Hart Modem

Quick Installation Guide

00825-0100-4716, Rev DA October 2009

Rosemount 3095 MultiVariable

STEP 3 CONTINUED...

Installing the HART Modem

After installing the 3095 Engineering Assistant, the HART modem configuration window automatically appears when the 3095 Engineering Assistant is opened. If this window is canceled, the HART modem may be installed manually with the following procedure.

1.Close AMS. From the Start Menu select Programs > 3095 Engineering Assistant > AMS Network.

2.Select Add from the AMS Network Configuration window. A “Select AMS Network Component Type” window will open.

3.Select Hart Modem.

4.Select Install.

5.Step through the Wizard. A prompt will inquire a COMM PORT. A typical default is “COMM 1”.

6.Select OK. Close out of the AMS Network Configuration window.

7.Re-open the HART Modem Properties. Click on the Connection tab and set the Retry Count to 5. Click the Advanced tab and check the Multidrop checkbox and set the Address Range as 0 to 2.

8.The configuration change will activate when 3095 Engineering Assistant is launched.

NOTE

Exit from the program if a Palm Pilot HotSync or any other program is shared with the

COMM PORT.

3095 Engineering Assistant (EA) for FOUNDATION Fieldbus

1.Install the 3095 Engineering Assistant for FOUNDATION Fieldbus Program and the FOUNDATION fieldbus communication card drivers.

a.Place CD-ROM disk 2 into the drive.

b.Browse and select 3095 Engineering Assistant for FOUNDATION Fieldbus software application from Windows NT, 2000, or XP

c. Open the ReadMe.txt file and follow the instructions provided. 2. Install the FOUNDATION Fieldbus communication card.

a.Insert either the PCMCIA card or PCI card into the computer, following the instructions provided with the communications card.

3. Connect the 3095 transmitter to computer and establish communications.

a.Connect the 9-pin communications cable into the FOUNDATION Fieldbus card port located in the computer.

b.Connect communication wiring to connection ports labeled “D+” and “D-”.

c. Open the transmitter cover on the side marked “Field Terminals” and connect the communication wires to the two 3095 transmitter terminals labeled “Fieldbus Wiring”.

4.Select the 3095 Engineering Assistant for FOUNDATION Fieldbus from the program menu or use the 3095 EA FOUNDATION fieldbus shortcut icon.

11