Gefen EXT-IP-2-RS2322 user manual Advanced Operation

Page 24

Advanced Operation

Commands

#help

#show_ipconfig #set_ipadd #set_netmask #set_gateway #set_http_port #set_tcp_term_port #set_udp_port #show_ver_data #show_telnet_pass #set_telnet_pass #use_tcp_term_pass #set_udp_rip #set_udp_rport #use_udp_access #use_udp_echo #use_tcp_access #set_serial_params #show_serial_params #set_serial_mode #show_serial_mode #show_serial_connect #set_serial_descr #show_serial_descr #set_tcp_br_port #set_udp_br_port #set_udp_remote_br #set_udp_echo_br #use_discovery #set_add_delim #set_start_del #set_end_del #set_send_time_out #set_send_byte_cnt #show_del_prms #set_device_descr #show_device_descr #show_me #system_wide_reset

page 14

Image 24
Contents IP to RS-232 Important Safety Instructions Warranty Information Contacting Gefen Technical Support Operating Notes Web siteFeatures and Packing List FeaturesPacking List Vii Table of Contents Page Page Getting Started IP to 2xRS-232 Converter IntroductionIntroduction Installation Sample Wiring DiagramConnection Instructions Page Page Advanced Operation RS-232 and IP Configuration Configuration using the Gefen Discovery ToolConfiguration using RS-232 Diagram 2.1 Configuration using a null-modem cableInformation Commands Commands #help ExampleAdvanced Operation #setadddelim #setdevicedescr #setenddel #setgateway #sethttpport #setipadd #setnetmask #setsendbytecnt #setsendtimeout #setserialdescr #setserialmode #setserialparams Baud Rate = 19200 Bps Line Delay = 1000 ms #setstartdel #settcpbrport #settcptermport #settelnetpass #setudpbrport #setudpechobr #setudpport #setudpremotebr #setudprip #setudprport #showdelprms #showdevicedescr #showipconfig #showme #showserialdescr #showserialmode #showserialparams #showtelnetpass #showverdata #systemwidereset Param1 Value#usediscovery #usetcpaccess #usetcptermpass #useudpaccess #useudpecho Using the built-in Web Interface Web InterfaceHelp RS-232 Mode RS-232Select RS-232 Port DescriptionBaud Rate Data BitsParity Stop BitsLine Delay ms Force Send msForce Send bytes Add Delimiters to data sent Use Start DelimiterStart Delimiter Value Use End DelimiterEnd Delimiter Value TCP PortUDP Local Port Set Defaults Destination IPDestination Port UDP EchoNetwork tab MAC AddressMode IP AddressGateway Http PortEnable TCP Access Require Password on ConnectOld Password User NameNew Password Confirm PasswordTerminal Port Enable UDP Access Enable UDP EchoUDP Port Enable Discovery Destination UDP IP AddressDestination UDP Port Download Download Current Configuration Browse... Restore ConfigurationRestore System tabBrowse... Firmware Update UpdateFactory Reset ResetPage Appendix Default Settings RS-232 SettingsIP Settings NetworkSpecifications Connectors, Indicators, and Controls RS-232Page Nordhoff St., Chatsworth CA