Gefen EXT-IP-2-RS2322 user manual Destination IP, Destination Port, UDP Echo, Set Defaults, Save

Page 69

Web Interface

Advanced Operation

Destination IP

Enter the destination (where the data will be sent) IP address in this field.

Range (per byte): 0 ... 255

Destination Port

Enter the destination port in this field.

Range: 1024 ... 65535

UDP Echo

Useful in troubleshooting and measuring response times and end-to-end connectivity.

Options: Enable (checked), Disable (unchecked)

Set Defaults

Click this button to reset RS-232 settings to their default values.

Save

Click this button to save any changes.

page 59

Image 69

Contents

IP to RS-232 Important Safety Instructions Warranty Information Contacting Gefen Technical Support Web site Operating NotesFeatures and Packing List FeaturesPacking List Vii Table of Contents Page Page Getting Started Introduction IP to 2xRS-232 ConverterIntroduction Installation Sample Wiring DiagramConnection Instructions Page Page Advanced Operation Configuration using the Gefen Discovery Tool RS-232 and IP ConfigurationDiagram 2.1 Configuration using a null-modem cable Configuration using RS-232Information Commands Commands Example #helpAdvanced Operation #setadddelim #setdevicedescr #setenddel #setgateway #sethttpport #setipadd #setnetmask #setsendbytecnt #setsendtimeout #setserialdescr #setserialmode #setserialparams Baud Rate = 19200 Bps Line Delay = 1000 ms #setstartdel #settcpbrport #settcptermport #settelnetpass #setudpbrport #setudpechobr #setudpport #setudpremotebr #setudprip #setudprport #showdelprms #showdevicedescr #showipconfig #showme #showserialdescr #showserialmode #showserialparams #showtelnetpass #showverdata Param1 Value #systemwidereset#usediscovery #usetcpaccess #usetcptermpass #useudpaccess #useudpecho Using the built-in Web Interface Web InterfaceHelp RS-232 RS-232 ModeSelect RS-232 Port DescriptionData Bits Baud RateParity Stop Bits Line Delay ms Force Send ms Force Send bytes Use Start Delimiter Add Delimiters to data sentStart Delimiter Value Use End DelimiterEnd Delimiter Value TCP PortUDP Local Port Destination IP Set DefaultsDestination Port UDP EchoMAC Address Network tabMode IP AddressHttp Port GatewayRequire Password on Connect Enable TCP AccessOld Password User NameNew Password Confirm PasswordTerminal Port Enable UDP Access Enable UDP EchoUDP Port Enable Discovery Destination UDP IP AddressDestination UDP Port Browse... Restore Configuration Download Download Current ConfigurationRestore System tabUpdate Browse... Firmware UpdateFactory Reset ResetPage Appendix RS-232 Settings Default SettingsNetwork IP SettingsConnectors, Indicators, and Controls RS-232 SpecificationsPage Nordhoff St., Chatsworth CA