Gefen EXT-IP-2-RS2322 user manual #setudprip

Page 46

Advanced Operation

Commands

#set_udp_rip

Sets the remote UDP IP address. The IP address must be entered using dot-decimal notation. Each digit can range between 0 and 255.

Syntax

#set_udp_rip param1

Parameters

param1IP address

Example

#set_udp_rip 192.168.1.205

New Remote UDP IP set to: 192.168.1.205

Related Commands

#set_udp_br_port #set_udp_echo_br #set_udp_remote_br #set_udp_echo_br

page 36

Image 46

Contents

IP to RS-232 Important Safety Instructions Warranty Information Contacting Gefen Technical Support Operating Notes Web siteFeatures Features and Packing ListPacking List Vii Table of Contents Page Page Getting Started IP to 2xRS-232 Converter IntroductionIntroduction Sample Wiring Diagram InstallationConnection Instructions Page Page Advanced Operation RS-232 and IP Configuration Configuration using the Gefen Discovery ToolConfiguration using RS-232 Diagram 2.1 Configuration using a null-modem cableInformation Commands Commands #help ExampleAdvanced Operation #setadddelim #setdevicedescr #setenddel #setgateway #sethttpport #setipadd #setnetmask #setsendbytecnt #setsendtimeout #setserialdescr #setserialmode #setserialparams Baud Rate = 19200 Bps Line Delay = 1000 ms #setstartdel #settcpbrport #settcptermport #settelnetpass #setudpbrport #setudpechobr #setudpport #setudpremotebr #setudprip #setudprport #showdelprms #showdevicedescr #showipconfig #showme #showserialdescr #showserialmode #showserialparams #showtelnetpass #showverdata #systemwidereset Param1 Value#usediscovery #usetcpaccess #usetcptermpass #useudpaccess #useudpecho Web Interface Using the built-in Web InterfaceHelp Select RS-232 Port RS-232 ModeRS-232 DescriptionParity Baud RateData Bits Stop BitsForce Send ms Line Delay msForce Send bytes Start Delimiter Value Add Delimiters to data sentUse Start Delimiter Use End DelimiterTCP Port End Delimiter ValueUDP Local Port Destination Port Set DefaultsDestination IP UDP EchoMode Network tabMAC Address IP AddressGateway Http PortOld Password Enable TCP AccessRequire Password on Connect User NameConfirm Password New PasswordTerminal Port Enable UDP Echo Enable UDP AccessUDP Port Destination UDP IP Address Enable DiscoveryDestination UDP Port Restore Download Download Current ConfigurationBrowse... Restore Configuration System tabFactory Reset Browse... Firmware UpdateUpdate ResetPage Appendix Default Settings RS-232 SettingsIP Settings NetworkSpecifications Connectors, Indicators, and Controls RS-232Page Nordhoff St., Chatsworth CA