Gefen EXT-IP-2-RS2322 user manual #usetcpaccess

Page 59

Advanced Operation

Commands

#use_tcp_access

Enables or disables TCP access mode. This mode must be enabled before using RS-232 command to configure the IP to 2 x RS-232 Converter.

Syntax

#use_tcp_access param1

Parameters

param1

Value

[0 ... 1]

Value Description

0Disable TCP access

1Enable TCP access

Example

#use_tcp_access 1

TCP Access is set to Enabled

Related Commands

#set_tcp_br_port #set_tcp_term_port #set_telnet_pass #use_tcp_term_pass

page 49

Image 59

Contents IP to RS-232 Important Safety Instructions Warranty Information Contacting Gefen Technical Support Web site Operating NotesPacking List Features and Packing ListFeatures Vii Table of Contents Page Page Getting Started Introduction IP to 2xRS-232 ConverterIntroduction Connection Instructions InstallationSample Wiring Diagram Page Page Advanced Operation Configuration using the Gefen Discovery Tool RS-232 and IP ConfigurationDiagram 2.1 Configuration using a null-modem cable Configuration using RS-232Information Commands Commands Example #helpAdvanced Operation #setadddelim #setdevicedescr #setenddel #setgateway #sethttpport #setipadd #setnetmask #setsendbytecnt #setsendtimeout #setserialdescr #setserialmode #setserialparams Baud Rate = 19200 Bps Line Delay = 1000 ms #setstartdel #settcpbrport #settcptermport #settelnetpass #setudpbrport #setudpechobr #setudpport #setudpremotebr #setudprip #setudprport #showdelprms #showdevicedescr #showipconfig #showme #showserialdescr #showserialmode #showserialparams #showtelnetpass #showverdata Param1 Value #systemwidereset#usediscovery #usetcpaccess #usetcptermpass #useudpaccess #useudpecho Help Using the built-in Web InterfaceWeb Interface Description RS-232 ModeRS-232 Select RS-232 PortStop Bits Baud RateData Bits ParityForce Send bytes Line Delay msForce Send ms Use End Delimiter Add Delimiters to data sentUse Start Delimiter Start Delimiter ValueUDP Local Port End Delimiter ValueTCP Port UDP Echo Set DefaultsDestination IP Destination PortIP Address Network tabMAC Address ModeHttp Port GatewayUser Name Enable TCP AccessRequire Password on Connect Old PasswordTerminal Port New PasswordConfirm Password UDP Port Enable UDP AccessEnable UDP Echo Destination UDP Port Enable DiscoveryDestination UDP IP Address System tab Download Download Current ConfigurationBrowse... Restore Configuration RestoreReset Browse... Firmware UpdateUpdate Factory ResetPage Appendix RS-232 Settings Default SettingsNetwork IP SettingsConnectors, Indicators, and Controls RS-232 SpecificationsPage Nordhoff St., Chatsworth CA