Gefen EXT-IP-2-RS2322 user manual Baud Rate, Data Bits, Parity, Stop Bits

Page 65

Web Interface

Advanced Operation

Baud Rate

Select the baud rate used by the RS-232 device from this drop-down list.

Options: 110, 300, 600, 1200, 2400, 4800, 9600, 14400, 19200, 28800

Data Bits

Select the number of data bits in each character from this drop-down list.

For most applications, 8 data bits should be selected. 9 data bits are rarely used.

Options: 8, 9

Parity

Select the parity bit type from this drop-down list.

Options: None, Even, Even Stick, Odd, Odd Stick

Stop Bits

Select the number of stop bits from this drop-down list.

Options: 1, 2

page 55

Image 65 Contents
IP to RS-232 Important Safety Instructions Warranty Information Contacting Gefen Technical Support Web site Operating NotesPacking List Features and Packing ListFeatures Vii Table of Contents Page Page Getting Started Introduction IP to 2xRS-232 ConverterIntroduction Connection Instructions InstallationSample Wiring Diagram Page Page Advanced Operation Configuration using the Gefen Discovery Tool RS-232 and IP ConfigurationDiagram 2.1 Configuration using a null-modem cable Configuration using RS-232Information Commands Commands Example #helpAdvanced Operation #setadddelim #setdevicedescr #setenddel #setgateway #sethttpport #setipadd #setnetmask #setsendbytecnt #setsendtimeout #setserialdescr #setserialmode #setserialparams Baud Rate = 19200 Bps Line Delay = 1000 ms #setstartdel #settcpbrport #settcptermport #settelnetpass #setudpbrport #setudpechobr #setudpport #setudpremotebr #setudprip #setudprport #showdelprms #showdevicedescr #showipconfig #showme #showserialdescr #showserialmode #showserialparams #showtelnetpass #showverdata Param1 Value #systemwidereset#usediscovery #usetcpaccess #usetcptermpass #useudpaccess #useudpecho Help Using the built-in Web InterfaceWeb Interface RS-232 RS-232 ModeSelect RS-232 Port DescriptionData Bits Baud RateParity Stop BitsForce Send bytes Line Delay msForce Send ms Use Start Delimiter Add Delimiters to data sentStart Delimiter Value Use End DelimiterUDP Local Port End Delimiter ValueTCP Port Destination IP Set DefaultsDestination Port UDP EchoMAC Address Network tabMode IP AddressHttp Port GatewayRequire Password on Connect Enable TCP AccessOld Password User NameTerminal Port New PasswordConfirm Password UDP Port Enable UDP AccessEnable UDP Echo Destination UDP Port Enable DiscoveryDestination UDP IP Address Browse... Restore Configuration Download Download Current ConfigurationRestore System tabUpdate Browse... Firmware UpdateFactory Reset ResetPage Appendix RS-232 Settings Default SettingsNetwork IP SettingsConnectors, Indicators, and Controls RS-232 SpecificationsPage Nordhoff St., Chatsworth CA