Gefen EXT-IP-2-RS2322 user manual #setgateway

Page 28

Advanced Operation

Commands

#set_gateway

Sets the gateway address. The gateway must be typed using dot-decimal notation. The matrix must be rebooted after executing this command. The default gateway is 192.168.1.1.

Syntax

#sgateway param1

Parameters

param1Gateway

Example

#set_gateway 10.5.64.1

New IP Gateway set to: 10.5.64.1

Related Commands

#set_add_delim #set_ipadd #set_netmask #show_ipconfig

page 18

Image 28

Contents

IP to RS-232 Important Safety Instructions Warranty Information Contacting Gefen Technical Support Operating Notes Web siteFeatures Features and Packing ListPacking List Vii Table of Contents Page Page Getting Started IP to 2xRS-232 Converter IntroductionIntroduction Sample Wiring Diagram InstallationConnection Instructions Page Page Advanced Operation RS-232 and IP Configuration Configuration using the Gefen Discovery ToolConfiguration using RS-232 Diagram 2.1 Configuration using a null-modem cableInformation Commands Commands #help ExampleAdvanced Operation #setadddelim #setdevicedescr #setenddel #setgateway #sethttpport #setipadd #setnetmask #setsendbytecnt #setsendtimeout #setserialdescr #setserialmode #setserialparams Baud Rate = 19200 Bps Line Delay = 1000 ms #setstartdel #settcpbrport #settcptermport #settelnetpass #setudpbrport #setudpechobr #setudpport #setudpremotebr #setudprip #setudprport #showdelprms #showdevicedescr #showipconfig #showme #showserialdescr #showserialmode #showserialparams #showtelnetpass #showverdata #systemwidereset Param1 Value#usediscovery #usetcpaccess #usetcptermpass #useudpaccess #useudpecho Web Interface Using the built-in Web InterfaceHelp RS-232 Mode RS-232Select RS-232 Port DescriptionBaud Rate Data BitsParity Stop BitsForce Send ms Line Delay msForce Send bytes Add Delimiters to data sent Use Start DelimiterStart Delimiter Value Use End DelimiterTCP Port End Delimiter ValueUDP Local Port Set Defaults Destination IPDestination Port UDP EchoNetwork tab MAC AddressMode IP AddressGateway Http PortEnable TCP Access Require Password on ConnectOld Password User NameConfirm Password New PasswordTerminal Port Enable UDP Echo Enable UDP AccessUDP Port Destination UDP IP Address Enable DiscoveryDestination UDP Port Download Download Current Configuration Browse... Restore ConfigurationRestore System tabBrowse... Firmware Update UpdateFactory Reset ResetPage Appendix Default Settings RS-232 SettingsIP Settings NetworkSpecifications Connectors, Indicators, and Controls RS-232Page Nordhoff St., Chatsworth CA