Gefen EXT-IP-2-RS2322 user manual Introduction

Page 13

Introduction

Getting Started

ID 1

2

3

4

5

6

Name

IP Reset

RS-232 1

Power

5V DC

IP control

RS-232 2

Description

Resets the unit to its default IP settings.

Connect an RS-232 cable from this port to an RS-232 device. See Installation (page 4) for more information.

This LED will glow bright blue when the unit is powered.

Connect the included 5V DC power supply to this power receptacle.

Connect an Ethernet cable between

this jack and an IP-based automation control device

Connect an RS-232 cable from this port to an RS-232 device. See Installation (page 4) for more information.

page 3

Image 13

Contents

IP to RS-232 Important Safety Instructions Warranty Information Contacting Gefen Technical Support Web site Operating NotesFeatures Features and Packing ListPacking List Vii Table of Contents Page Page Getting Started Introduction IP to 2xRS-232 ConverterIntroduction Sample Wiring Diagram InstallationConnection Instructions Page Page Advanced Operation Configuration using the Gefen Discovery Tool RS-232 and IP ConfigurationDiagram 2.1 Configuration using a null-modem cable Configuration using RS-232Information Commands Commands Example #helpAdvanced Operation #setadddelim #setdevicedescr #setenddel #setgateway #sethttpport #setipadd #setnetmask #setsendbytecnt #setsendtimeout #setserialdescr #setserialmode #setserialparams Baud Rate = 19200 Bps Line Delay = 1000 ms #setstartdel #settcpbrport #settcptermport #settelnetpass #setudpbrport #setudpechobr #setudpport #setudpremotebr #setudprip #setudprport #showdelprms #showdevicedescr #showipconfig #showme #showserialdescr #showserialmode #showserialparams #showtelnetpass #showverdata Param1 Value #systemwidereset#usediscovery #usetcpaccess #usetcptermpass #useudpaccess #useudpecho Web Interface Using the built-in Web InterfaceHelp RS-232 RS-232 ModeSelect RS-232 Port DescriptionData Bits Baud RateParity Stop BitsForce Send ms Line Delay msForce Send bytes Use Start Delimiter Add Delimiters to data sentStart Delimiter Value Use End DelimiterTCP Port End Delimiter ValueUDP Local Port Destination IP Set DefaultsDestination Port UDP EchoMAC Address Network tabMode IP AddressHttp Port GatewayRequire Password on Connect Enable TCP AccessOld Password User NameConfirm Password New PasswordTerminal Port Enable UDP Echo Enable UDP AccessUDP Port Destination UDP IP Address Enable DiscoveryDestination UDP Port Browse... Restore Configuration Download Download Current ConfigurationRestore System tabUpdate Browse... Firmware UpdateFactory Reset ResetPage Appendix RS-232 Settings Default SettingsNetwork IP SettingsConnectors, Indicators, and Controls RS-232 SpecificationsPage Nordhoff St., Chatsworth CA