Gefen EXT-IP-2-RS2322 user manual #setnetmask

Page 31

Advanced Operation

Commands

#set_netmask

Sets the subnet mask. The subnet mask must be entered using dot-decimal notation. The unit must be rebooted after executing this command. The default net mask is 255.255.255.0.

Syntax

#snetmask param1

Parameters

param1Net mask

Example

#snetmask 255.255.0.0

New IP Mask set to: 255.255.0.0

Related Commands

#set_gateway #set_ipadd #set_http_port #show_ipconfig

page 21

Image 31

Contents IP to RS-232 Important Safety Instructions Warranty Information Contacting Gefen Technical Support Web site Operating NotesFeatures Features and Packing ListPacking List Vii Table of Contents Page Page Getting Started Introduction IP to 2xRS-232 ConverterIntroduction Sample Wiring Diagram InstallationConnection Instructions Page Page Advanced Operation Configuration using the Gefen Discovery Tool RS-232 and IP ConfigurationDiagram 2.1 Configuration using a null-modem cable Configuration using RS-232Information Commands Commands Example #helpAdvanced Operation #setadddelim #setdevicedescr #setenddel #setgateway #sethttpport #setipadd #setnetmask #setsendbytecnt #setsendtimeout #setserialdescr #setserialmode #setserialparams Baud Rate = 19200 Bps Line Delay = 1000 ms #setstartdel #settcpbrport #settcptermport #settelnetpass #setudpbrport #setudpechobr #setudpport #setudpremotebr #setudprip #setudprport #showdelprms #showdevicedescr #showipconfig #showme #showserialdescr #showserialmode #showserialparams #showtelnetpass #showverdata Param1 Value #systemwidereset#usediscovery #usetcpaccess #usetcptermpass #useudpaccess #useudpecho Web Interface Using the built-in Web InterfaceHelp Description RS-232 ModeRS-232 Select RS-232 PortStop Bits Baud RateData Bits ParityForce Send ms Line Delay msForce Send bytes Use End Delimiter Add Delimiters to data sentUse Start Delimiter Start Delimiter ValueTCP Port End Delimiter ValueUDP Local Port UDP Echo Set DefaultsDestination IP Destination PortIP Address Network tabMAC Address ModeHttp Port GatewayUser Name Enable TCP AccessRequire Password on Connect Old PasswordConfirm Password New PasswordTerminal Port Enable UDP Echo Enable UDP AccessUDP Port Destination UDP IP Address Enable DiscoveryDestination UDP Port System tab Download Download Current ConfigurationBrowse... Restore Configuration RestoreReset Browse... Firmware UpdateUpdate Factory ResetPage Appendix RS-232 Settings Default SettingsNetwork IP SettingsConnectors, Indicators, and Controls RS-232 SpecificationsPage Nordhoff St., Chatsworth CA