Gefen EXT-IP-2-RS2322 user manual #showme

Page 51

Advanced Operation

Commands

#show_me

Enables or disables the flashing of the LED on the device. When enabled, the LED indicator will flash red and blue. The default setting is disabled.

Syntax

#show_me param1

Parameters

param1State

State Description

0Disabled

1Enabled

Example

#show_me 1

Show me is Enabled

Related Commands

#use_discovery

page 41

Image 51

Contents

IP to RS-232 Important Safety Instructions Warranty Information Contacting Gefen Technical Support Web site Operating NotesFeatures and Packing List FeaturesPacking List Vii Table of Contents Page Page Getting Started Introduction IP to 2xRS-232 ConverterIntroduction Installation Sample Wiring DiagramConnection Instructions Page Page Advanced Operation Configuration using the Gefen Discovery Tool RS-232 and IP ConfigurationDiagram 2.1 Configuration using a null-modem cable Configuration using RS-232Information Commands Commands Example #helpAdvanced Operation #setadddelim #setdevicedescr #setenddel #setgateway #sethttpport #setipadd #setnetmask #setsendbytecnt #setsendtimeout #setserialdescr #setserialmode #setserialparams Baud Rate = 19200 Bps Line Delay = 1000 ms #setstartdel #settcpbrport #settcptermport #settelnetpass #setudpbrport #setudpechobr #setudpport #setudpremotebr #setudprip #setudprport #showdelprms #showdevicedescr #showipconfig #showme #showserialdescr #showserialmode #showserialparams #showtelnetpass #showverdata Param1 Value #systemwidereset#usediscovery #usetcpaccess #usetcptermpass #useudpaccess #useudpecho Using the built-in Web Interface Web InterfaceHelp Description RS-232 ModeRS-232 Select RS-232 PortStop Bits Baud RateData Bits ParityLine Delay ms Force Send msForce Send bytes Use End Delimiter Add Delimiters to data sentUse Start Delimiter Start Delimiter ValueEnd Delimiter Value TCP PortUDP Local Port UDP Echo Set DefaultsDestination IP Destination PortIP Address Network tabMAC Address ModeHttp Port GatewayUser Name Enable TCP AccessRequire Password on Connect Old PasswordNew Password Confirm PasswordTerminal Port Enable UDP Access Enable UDP EchoUDP Port Enable Discovery Destination UDP IP AddressDestination UDP Port System tab Download Download Current ConfigurationBrowse... Restore Configuration RestoreReset Browse... Firmware UpdateUpdate Factory ResetPage Appendix RS-232 Settings Default SettingsNetwork IP SettingsConnectors, Indicators, and Controls RS-232 SpecificationsPage Nordhoff St., Chatsworth CA