Gefen EXT-IP-2-RS2322 user manual #setsendtimeout

Page 33

Advanced Operation

Commands

#set_send_time_out

Sets the time-out value for sending data collected from a device to the control system in Bridging Mode when a Start Delimiter and End Delimiter have been set. If no data has been collected for the specified time, the data is sent without waiting for the End Delimiter.

Syntax

#set_send_time_out param1

Parameters

param1	Serial port	[1	... 2]
param2	Time out (ms)	[0	... 255]

Example

#set_send_time_out 1 30

UART 1 bridging sent Time Out is set to 30 ms

Related Commands

#set_add_delim #set_end_del #set_serial_mode #set_start_del

page 23

Image 33

Contents

IP to RS-232 Important Safety Instructions Warranty Information Contacting Gefen Technical Support Web site Operating NotesFeatures and Packing List FeaturesPacking List Vii Table of Contents Page Page Getting Started Introduction IP to 2xRS-232 ConverterIntroduction Installation Sample Wiring DiagramConnection Instructions Page Page Advanced Operation Configuration using the Gefen Discovery Tool RS-232 and IP ConfigurationDiagram 2.1 Configuration using a null-modem cable Configuration using RS-232Information Commands Commands Example #helpAdvanced Operation #setadddelim #setdevicedescr #setenddel #setgateway #sethttpport #setipadd #setnetmask #setsendbytecnt #setsendtimeout #setserialdescr #setserialmode #setserialparams Baud Rate = 19200 Bps Line Delay = 1000 ms #setstartdel #settcpbrport #settcptermport #settelnetpass #setudpbrport #setudpechobr #setudpport #setudpremotebr #setudprip #setudprport #showdelprms #showdevicedescr #showipconfig #showme #showserialdescr #showserialmode #showserialparams #showtelnetpass #showverdata Param1 Value #systemwidereset#usediscovery #usetcpaccess #usetcptermpass #useudpaccess #useudpecho Using the built-in Web Interface Web InterfaceHelp RS-232 RS-232 ModeSelect RS-232 Port DescriptionData Bits Baud RateParity Stop BitsLine Delay ms Force Send msForce Send bytes Use Start Delimiter Add Delimiters to data sentStart Delimiter Value Use End DelimiterEnd Delimiter Value TCP PortUDP Local Port Destination IP Set DefaultsDestination Port UDP EchoMAC Address Network tabMode IP AddressHttp Port GatewayRequire Password on Connect Enable TCP AccessOld Password User NameNew Password Confirm PasswordTerminal Port Enable UDP Access Enable UDP EchoUDP Port Enable Discovery Destination UDP IP AddressDestination UDP Port Browse... Restore Configuration Download Download Current ConfigurationRestore System tabUpdate Browse... Firmware UpdateFactory Reset ResetPage Appendix RS-232 Settings Default SettingsNetwork IP SettingsConnectors, Indicators, and Controls RS-232 SpecificationsPage Nordhoff St., Chatsworth CA